2 * OMAP2 Power Management Routines
4 * Copyright (C) 2005 Texas Instruments, Inc.
5 * Copyright (C) 2006-2008 Nokia Corporation
8 * Richard Woodruff <r-woodruff2@ti.com>
11 * Amit Kucheria <amit.kucheria@nokia.com>
12 * Igor Stoppa <igor.stoppa@nokia.com>
14 * Based on pm.c for omap1
16 * This program is free software; you can redistribute it and/or modify
17 * it under the terms of the GNU General Public License version 2 as
18 * published by the Free Software Foundation.
21 #include <linux/suspend.h>
22 #include <linux/sched.h>
23 #include <linux/proc_fs.h>
24 #include <linux/interrupt.h>
25 #include <linux/sysfs.h>
26 #include <linux/module.h>
27 #include <linux/delay.h>
28 #include <linux/clk-provider.h>
29 #include <linux/irq.h>
30 #include <linux/time.h>
31 #include <linux/gpio.h>
32 #include <linux/platform_data/gpio-omap.h>
34 #include <asm/fncpy.h>
36 #include <asm/mach/time.h>
37 #include <asm/mach/irq.h>
38 #include <asm/mach-types.h>
39 #include <asm/system_misc.h>
41 #include <linux/omap-dma.h>
47 #include "prm-regbits-24xx.h"
49 #include "cm-regbits-24xx.h"
54 #include "powerdomain.h"
55 #include "clockdomain.h"
57 static void (*omap2_sram_suspend)(u32 dllctrl, void __iomem *sdrc_dlla_ctrl,
58 void __iomem *sdrc_power);
60 static struct powerdomain *mpu_pwrdm, *core_pwrdm;
61 static struct clockdomain *dsp_clkdm, *mpu_clkdm, *wkup_clkdm, *gfx_clkdm;
63 static struct clk *osc_ck, *emul_ck;
65 static int omap2_enter_full_retention(void)
69 /* There is 1 reference hold for all children of the oscillator
70 * clock, the following will remove it. If no one else uses the
71 * oscillator itself it will be disabled if/when we enter retention
76 /* Clear old wake-up events */
77 /* REVISIT: These write to reserved bits? */
78 omap_prm_clear_mod_irqs(CORE_MOD, PM_WKST1, ~0);
79 omap_prm_clear_mod_irqs(CORE_MOD, OMAP24XX_PM_WKST2, ~0);
80 omap_prm_clear_mod_irqs(WKUP_MOD, PM_WKST, ~0);
82 pwrdm_set_next_pwrst(core_pwrdm, PWRDM_POWER_RET);
83 pwrdm_set_next_pwrst(mpu_pwrdm, PWRDM_POWER_RET);
85 /* Workaround to kill USB */
86 l = omap_ctrl_readl(OMAP2_CONTROL_DEVCONF0) | OMAP24XX_USBSTANDBYCTRL;
87 omap_ctrl_writel(l, OMAP2_CONTROL_DEVCONF0);
89 omap2_gpio_prepare_for_idle(0);
91 /* One last check for pending IRQs to avoid extra latency due
92 * to sleeping unnecessarily. */
93 if (omap_irq_pending())
96 /* Jump to SRAM suspend code */
97 omap2_sram_suspend(sdrc_read_reg(SDRC_DLLA_CTRL),
98 OMAP_SDRC_REGADDR(SDRC_DLLA_CTRL),
99 OMAP_SDRC_REGADDR(SDRC_POWER));
102 omap2_gpio_resume_after_idle();
106 /* clear CORE wake-up events */
107 omap_prm_clear_mod_irqs(CORE_MOD, PM_WKST1, ~0);
108 omap_prm_clear_mod_irqs(CORE_MOD, OMAP24XX_PM_WKST2, ~0);
110 /* wakeup domain events - bit 1: GPT1, bit5 GPIO */
111 omap_prm_clear_mod_irqs(WKUP_MOD, PM_WKST, 0x4 | 0x1);
113 /* MPU domain wake events */
114 omap_prm_clear_mod_irqs(OCP_MOD, OMAP2_PRCM_IRQSTATUS_MPU_OFFSET, 0x1);
116 omap_prm_clear_mod_irqs(OCP_MOD, OMAP2_PRCM_IRQSTATUS_MPU_OFFSET, 0x20);
118 pwrdm_set_next_pwrst(mpu_pwrdm, PWRDM_POWER_ON);
119 pwrdm_set_next_pwrst(core_pwrdm, PWRDM_POWER_ON);
124 static int sti_console_enabled;
126 static int omap2_allow_mpu_retention(void)
128 if (!omap2xxx_cm_mpu_retention_allowed())
130 if (sti_console_enabled)
136 static void omap2_enter_mpu_retention(void)
140 /* The peripherals seem not to be able to wake up the MPU when
141 * it is in retention mode. */
142 if (omap2_allow_mpu_retention()) {
143 /* REVISIT: These write to reserved bits? */
144 omap_prm_clear_mod_irqs(CORE_MOD, PM_WKST1, ~0);
145 omap_prm_clear_mod_irqs(CORE_MOD, OMAP24XX_PM_WKST2, ~0);
146 omap_prm_clear_mod_irqs(WKUP_MOD, PM_WKST, ~0);
148 /* Try to enter MPU retention */
149 pwrdm_set_next_pwrst(mpu_pwrdm, PWRDM_POWER_RET);
152 /* Block MPU retention */
153 pwrdm_set_next_pwrst(mpu_pwrdm, PWRDM_POWER_ON);
157 asm("mcr p15, 0, %0, c7, c0, 4" : : "r" (zero) : "memory", "cc");
159 pwrdm_set_next_pwrst(mpu_pwrdm, PWRDM_POWER_ON);
162 static int omap2_can_sleep(void)
164 if (omap2xxx_cm_fclks_active())
166 if (__clk_is_enabled(osc_ck))
168 if (omap_dma_running())
174 static void omap2_pm_idle(void)
176 if (!omap2_can_sleep()) {
177 if (omap_irq_pending())
179 omap2_enter_mpu_retention();
183 if (omap_irq_pending())
186 omap2_enter_full_retention();
189 static void __init prcm_setup_regs(void)
191 int i, num_mem_banks;
192 struct powerdomain *pwrdm;
196 * XXX This should be handled by hwmod code or PRCM init code
198 omap2_prm_write_mod_reg(OMAP24XX_AUTOIDLE_MASK, OCP_MOD,
199 OMAP2_PRCM_SYSCONFIG_OFFSET);
202 * Set CORE powerdomain memory banks to retain their contents
205 num_mem_banks = pwrdm_get_mem_bank_count(core_pwrdm);
206 for (i = 0; i < num_mem_banks; i++)
207 pwrdm_set_mem_retst(core_pwrdm, i, PWRDM_POWER_RET);
209 pwrdm_set_logic_retst(core_pwrdm, PWRDM_POWER_RET);
211 pwrdm_set_logic_retst(mpu_pwrdm, PWRDM_POWER_RET);
213 /* Force-power down DSP, GFX powerdomains */
215 pwrdm = clkdm_get_pwrdm(dsp_clkdm);
216 pwrdm_set_next_pwrst(pwrdm, PWRDM_POWER_OFF);
218 pwrdm = clkdm_get_pwrdm(gfx_clkdm);
219 pwrdm_set_next_pwrst(pwrdm, PWRDM_POWER_OFF);
221 /* Enable hardware-supervised idle for all clkdms */
222 clkdm_for_each(omap_pm_clkdms_setup, NULL);
223 clkdm_add_wkdep(mpu_clkdm, wkup_clkdm);
225 omap_common_suspend_init(omap2_enter_full_retention);
227 /* REVISIT: Configure number of 32 kHz clock cycles for sys_clk
229 omap2_prm_write_mod_reg(15 << OMAP_SETUP_TIME_SHIFT, OMAP24XX_GR_MOD,
230 OMAP2_PRCM_CLKSSETUP_OFFSET);
232 /* Configure automatic voltage transition */
233 omap2_prm_write_mod_reg(2 << OMAP_SETUP_TIME_SHIFT, OMAP24XX_GR_MOD,
234 OMAP2_PRCM_VOLTSETUP_OFFSET);
235 omap2_prm_write_mod_reg(OMAP24XX_AUTO_EXTVOLT_MASK |
236 (0x1 << OMAP24XX_SETOFF_LEVEL_SHIFT) |
237 OMAP24XX_MEMRETCTRL_MASK |
238 (0x1 << OMAP24XX_SETRET_LEVEL_SHIFT) |
239 (0x0 << OMAP24XX_VOLT_LEVEL_SHIFT),
240 OMAP24XX_GR_MOD, OMAP2_PRCM_VOLTCTRL_OFFSET);
242 /* Enable wake-up events */
243 omap2_prm_write_mod_reg(OMAP24XX_EN_GPIOS_MASK | OMAP24XX_EN_GPT1_MASK,
246 /* Enable SYS_CLKEN control when all domains idle */
247 omap2_prm_set_mod_reg_bits(OMAP_AUTOEXTCLKMODE_MASK, OMAP24XX_GR_MOD,
248 OMAP2_PRCM_CLKSRC_CTRL_OFFSET);
251 int __init omap2_pm_init(void)
255 printk(KERN_INFO "Power Management for OMAP2 initializing\n");
256 l = omap2_prm_read_mod_reg(OCP_MOD, OMAP2_PRCM_REVISION_OFFSET);
257 printk(KERN_INFO "PRCM revision %d.%d\n", (l >> 4) & 0x0f, l & 0x0f);
259 /* Look up important powerdomains */
261 mpu_pwrdm = pwrdm_lookup("mpu_pwrdm");
263 pr_err("PM: mpu_pwrdm not found\n");
265 core_pwrdm = pwrdm_lookup("core_pwrdm");
267 pr_err("PM: core_pwrdm not found\n");
269 /* Look up important clockdomains */
271 mpu_clkdm = clkdm_lookup("mpu_clkdm");
273 pr_err("PM: mpu_clkdm not found\n");
275 wkup_clkdm = clkdm_lookup("wkup_clkdm");
277 pr_err("PM: wkup_clkdm not found\n");
279 dsp_clkdm = clkdm_lookup("dsp_clkdm");
281 pr_err("PM: dsp_clkdm not found\n");
283 gfx_clkdm = clkdm_lookup("gfx_clkdm");
285 pr_err("PM: gfx_clkdm not found\n");
288 osc_ck = clk_get(NULL, "osc_ck");
289 if (IS_ERR(osc_ck)) {
290 printk(KERN_ERR "could not get osc_ck\n");
294 if (cpu_is_omap242x()) {
295 emul_ck = clk_get(NULL, "emul_ck");
296 if (IS_ERR(emul_ck)) {
297 printk(KERN_ERR "could not get emul_ck\n");
306 * We copy the assembler sleep/wakeup routines to SRAM.
307 * These routines need to be in SRAM as that's the only
308 * memory the MPU can see when it wakes up after the entire
311 omap2_sram_suspend = omap_sram_push(omap24xx_cpu_suspend,
312 omap24xx_cpu_suspend_sz);
314 arm_pm_idle = omap2_pm_idle;