3 source "arch/arm/plat-mxc/devices/Kconfig"
5 menu "Freescale MXC Implementations"
8 prompt "Freescale CPU family:"
14 This enables support for systems based on the Freescale i.MX1 family
19 This enables support for systems based on the Freescale i.MX2 family
24 This enables support for systems based on the Freescale i.MX25 family
29 This enables support for systems based on the Freescale i.MX3 family
34 This enables support for systems based on the Freescale i.MX51 family
38 source "arch/arm/mach-imx/Kconfig"
39 source "arch/arm/mach-mx3/Kconfig"
40 source "arch/arm/mach-mx5/Kconfig"
45 bool "Use IRQ priority"
47 Select this if you want to use prioritized IRQ handling.
48 This feature prevents higher priority ISR to be interrupted
49 by lower priority IRQ even IRQF_DISABLED flag is not set.
50 This may be useful in embedded applications, where are strong
51 requirements for timing.
52 Say N here, unless you have a specialized requirement.
61 tristate "Enable PWM driver"
64 Enable support for the i.MX PWM controller(s).
66 config MXC_DEBUG_BOARD
67 bool "Enable MXC debug board(for 3-stack)"
69 The debug board is an integral part of the MXC 3-stack(PDK)
70 platforms, it can be attached or removed from the peripheral
71 board. On debug board, several debug devices(ethernet, UART,
72 buttons, LEDs and JTAG) are implemented. Between the MCU and
73 these devices, a CPLD is added as a bridge which performs
74 data/address de-multiplexing and decode, signal level shift,
75 interrupt control and various board functions.
81 bool "Use EPIT instead of GPT"
84 Use EPIT as the system timer on systems that have it. Normally you
85 don't have a reason to do so as the EPIT has the same features and
86 uses the same clocks as the GPT. Anyway, on some systems the GPT
87 may be in use for other purposes.
95 config IMX_HAVE_IOMUX_V1
98 config ARCH_MXC_IOMUX_V3
101 config ARCH_MXC_AUDMUX_V1
104 config ARCH_MXC_AUDMUX_V2
109 select GENERIC_ALLOCATOR