1 # STK1000 customization
5 config BOARD_ATSTK100X_CUSTOM
6 bool "Non-default STK1002/STK1003/STK1004 jumper settings"
8 You will normally leave the jumpers on the CPU card at their
9 default settings. If you need to use certain peripherals,
10 you will need to change some of those jumpers.
12 if BOARD_ATSTK100X_CUSTOM
14 config BOARD_ATSTK100X_SW1_CUSTOM
15 bool "SW1: use SSC1 (not SPI0)"
17 This also prevents using the external DAC as an audio interface,
18 and means you can't initialize the on-board QVGA display.
20 config BOARD_ATSTK100X_SW2_CUSTOM
21 bool "SW2: use IRDA or TIMER0 (not UART-A, MMC/SD, and PS2-A)"
23 If you change this you'll want an updated boot loader putting
24 the console on UART-C not UART-A.
26 config BOARD_ATSTK100X_SW3_CUSTOM
27 bool "SW3: use TIMER1 (not SSC0 and GCLK)"
29 This also prevents using the external DAC as an audio interface.
31 config BOARD_ATSTK100X_SW4_CUSTOM
32 bool "SW4: use ISI/Camera (not GPIOs, SPI1, and PS2-B)"
34 To use the camera interface you'll need a custom card (on the
35 PCI-format connector) connect a video sensor.
37 config BOARD_ATSTK1002_SW5_CUSTOM
38 bool "SW5: use MACB1 (not LCDC)"
39 depends on BOARD_ATSTK1002
41 config BOARD_ATSTK1002_SW6_CUSTOM
42 bool "SW6: more GPIOs (not MACB0)"
43 depends on BOARD_ATSTK1002
47 config BOARD_ATSTK100X_SPI1
48 bool "Configure SPI1 controller"
49 depends on !BOARD_ATSTK100X_SW4_CUSTOM
51 All the signals for the second SPI controller are available on
52 GPIO lines and accessed through the J1 jumper block. Say "y"
53 here to configure that SPI controller.
55 config BOARD_ATSTK1000_J2_LED
57 default BOARD_ATSTK1000_J2_LED8 || BOARD_ATSTK1000_J2_RGB
60 prompt "LEDs connected to J2:"
61 depends on LEDS_GPIO && !BOARD_ATSTK100X_SW4_CUSTOM
64 Select this if you have jumpered the J2 jumper block to the
65 LED0..LED7 amber leds, or to the RGB leds, using a ten-pin
66 IDC cable. A default "heartbeat" trigger is provided, but
67 you can of course override this.
69 config BOARD_ATSTK1000_J2_LED8
72 Select this if J2 is jumpered to LED0..LED7 amber leds.
74 config BOARD_ATSTK1000_J2_RGB
77 Select this if J2 is jumpered to the RGB leds.
81 config BOARD_ATSTK1000_EXTDAC
83 depends on !BOARD_ATSTK100X_SW1_CUSTOM && !BOARD_ATSTK100X_SW3_CUSTOM