2 # PHY Layer Configuration
6 tristate "MDIO bus device drivers"
8 MDIO devices and driver infrastructure code.
13 tristate "Broadcom iProc MDIO bus controller"
14 depends on ARCH_BCM_IPROC || COMPILE_TEST
15 depends on HAS_IOMEM && OF_MDIO
17 This module provides a driver for the MDIO busses found in the
20 config MDIO_BCM_UNIMAC
21 tristate "Broadcom UniMAC MDIO bus controller"
22 depends on HAS_IOMEM && OF_MDIO
24 This module provides a driver for the Broadcom UniMAC MDIO busses.
25 This hardware can be found in the Broadcom GENET Ethernet MAC
26 controllers as well as some Broadcom Ethernet switches such as the
27 Starfighter 2 switches.
30 tristate "Bitbanged MDIO buses"
31 depends on !(MDIO_DEVICE=y && PHYLIB=m)
33 This module implements the MDIO bus protocol in software,
34 for use by low level drivers that export the ability to
35 drive the relevant pins.
43 This module provides a driver framework for MDIO bus
44 multiplexers which connect one of several child MDIO busses
45 to a parent bus. Switching between child busses is done by
46 device specific drivers.
48 config MDIO_BUS_MUX_BCM_IPROC
49 tristate "Broadcom iProc based MDIO bus multiplexers"
50 depends on OF && OF_MDIO && (ARCH_BCM_IPROC || COMPILE_TEST)
52 default ARCH_BCM_IPROC
54 This module provides a driver for MDIO bus multiplexers found in
55 iProc based Broadcom SoCs. This multiplexer connects one of several
56 child MDIO bus to a parent bus. Buses could be internal as well as
57 external and selection logic lies inside the same multiplexer.
59 config MDIO_BUS_MUX_GPIO
60 tristate "GPIO controlled MDIO bus multiplexers"
61 depends on OF_GPIO && OF_MDIO
64 This module provides a driver for MDIO bus multiplexers that
65 are controlled via GPIO lines. The multiplexer connects one of
66 several child MDIO busses to a parent bus. Child bus
67 selection is under the control of GPIO lines.
69 config MDIO_BUS_MUX_MMIOREG
70 tristate "MMIO device-controlled MDIO bus multiplexers"
71 depends on OF_MDIO && HAS_IOMEM
74 This module provides a driver for MDIO bus multiplexers that
75 are controlled via a simple memory-mapped device, like an FPGA.
76 The multiplexer connects one of several child MDIO busses to a
77 parent bus. Child bus selection is under the control of one of
80 Currently, only 8-bit registers are supported.
86 tristate "GPIO lib-based bitbanged MDIO buses"
87 depends on MDIO_BITBANG && GPIOLIB
89 Supports GPIO lib-based MDIO busses.
91 To compile this driver as a module, choose M here: the module
92 will be called mdio-gpio.
94 config MDIO_HISI_FEMAC
95 tristate "Hisilicon FEMAC MDIO bus controller"
96 depends on HAS_IOMEM && OF_MDIO
98 This module provides a driver for the MDIO busses found in the
99 Hisilicon SoC that have an Fast Ethernet MAC.
102 tristate "MOXA ART MDIO interface support"
103 depends on ARCH_MOXART
105 This driver supports the MDIO interface found in the network
106 interface units of the MOXA ART SoC
109 tristate "Octeon and some ThunderX SOCs MDIO buses"
111 depends on HAS_IOMEM && OF_MDIO
114 This module provides a driver for the Octeon and ThunderX MDIO
115 buses. It is required by the Octeon and ThunderX ethernet device
116 drivers on some systems.
119 tristate "Allwinner sun4i MDIO interface support"
120 depends on ARCH_SUNXI
122 This driver supports the MDIO interface found in the network
123 interface units of the Allwinner SoC that have an EMAC (A10,
127 tristate "ThunderX SOCs MDIO buses"
130 depends on !(MDIO_DEVICE=y && PHYLIB=m)
133 This driver supports the MDIO interfaces found on Cavium
134 ThunderX SoCs when the MDIO bus device appears as a PCI
138 tristate "APM X-Gene SoC MDIO bus controller"
139 depends on ARCH_XGENE || COMPILE_TEST
141 This module provides a driver for the MDIO busses found in the
147 tristate "PHY Device support and infrastructure"
148 depends on NETDEVICES
151 Ethernet controllers are usually attached to PHY
152 devices. This option provides infrastructure for
153 managing PHY devices.
160 config LED_TRIGGER_PHY
161 bool "Support LED triggers for tracking link state"
162 depends on LEDS_TRIGGERS
164 Adds support for a set of LED trigger events per-PHY. Link
165 state change will trigger the events, for consumption by an
166 LED class driver. There are triggers for each link speed currently
167 supported by the phy, and are of the form:
168 <mii bus id>:<phy>:<speed>
170 Where speed is in the form:
171 <Speed in megabits>Mbps or <Speed in gigabits>Gbps
174 comment "MII PHY device drivers"
179 Currently supports the am79c874
182 tristate "Aquantia PHYs"
184 Currently supports the Aquantia AQ1202, AQ2104, AQR105, AQR405
187 tristate "AT803X PHYs"
189 Currently supports the AT8030 and AT8035 model
192 tristate "Broadcom 63xx SOCs internal PHY"
194 select BCM_NET_PHYLIB
196 Currently supports the 6348 and 6358 PHYs.
199 tristate "Broadcom 7xxx SOCs internal PHYs"
200 select BCM_NET_PHYLIB
202 Currently supports the BCM7366, BCM7439, BCM7445, and
203 40nm and 65nm generation of BCM7xxx Set Top Box SoCs.
206 tristate "Broadcom BCM8706 and BCM8727 PHYs"
208 Currently supports the BCM8706 and BCM8727 10G Ethernet PHYs.
210 config BCM_CYGNUS_PHY
211 tristate "Broadcom Cygnus SoC internal PHY"
212 depends on ARCH_BCM_CYGNUS || COMPILE_TEST
213 depends on MDIO_BCM_IPROC
214 select BCM_NET_PHYLIB
216 This PHY driver is for the 1G internal PHYs of the Broadcom
219 Currently supports internal PHY's used in the BCM11300,
220 BCM11320, BCM11350, BCM11360, BCM58300, BCM58302,
221 BCM58303 & BCM58305 Broadcom Cygnus SoCs.
223 config BCM_NET_PHYLIB
227 tristate "Broadcom PHYs"
228 select BCM_NET_PHYLIB
230 Currently supports the BCM5411, BCM5421, BCM5461, BCM54616S, BCM5464,
231 BCM5481, BCM54810 and BCM5482 PHYs.
234 tristate "Cicada PHYs"
236 Currently supports the cis8204
239 tristate "Davicom PHYs"
241 Currently supports dm9161e and dm9131
244 tristate "Texas Instruments DP83848 PHY"
246 Supports the DP83848 PHY.
249 tristate "Texas Instruments DP83867 Gigabit PHY"
251 Currently supports the DP83867 PHY.
254 tristate "MDIO Bus/PHY emulation with fixed speed/link PHYs"
258 Adds the platform "fixed" MDIO Bus to cover the boards that use
259 PHYs that are not connected to the real MDIO bus.
261 Currently tested with mpc866ads and mpc8349e-mitx.
264 tristate "ICPlus PHYs"
266 Currently supports the IP175C and IP1001 PHYs.
268 config INTEL_XWAY_PHY
269 tristate "Intel XWAY PHYs"
271 Supports the Intel XWAY (former Lantiq) 11G and 22E PHYs.
272 These PHYs are marked as standalone chips under the names
273 PEF 7061, PEF 7071 and PEF 7072 or integrated into the Intel
274 SoCs xRX200, xRX300, xRX330, xRX350 and xRX550.
276 config LSI_ET1011C_PHY
277 tristate "LSI ET1011C PHY"
279 Supports the LSI ET1011C PHY.
282 tristate "Intel LXT PHYs"
284 Currently supports the lxt970, lxt971
287 tristate "Marvell PHYs"
289 Currently has a driver for the 88E1011S
292 tristate "Amlogic Meson GXL Internal PHY"
293 depends on ARCH_MESON || COMPILE_TEST
295 Currently has a driver for the Amlogic Meson GXL Internal PHY
298 tristate "Micrel PHYs"
300 Supports the KSZ9021, VSC8201, KS8001 PHYs.
303 tristate "Microchip PHYs"
305 Supports the LAN88XX PHYs.
308 tristate "Microsemi PHYs"
310 Currently supports VSC8530, VSC8531, VSC8540 and VSC8541 PHYs
313 tristate "National Semiconductor PHYs"
315 Currently supports the DP83865 PHY.
318 tristate "Quality Semiconductor PHYs"
320 Currently supports the qs6612
323 tristate "Realtek PHYs"
325 Supports the Realtek 821x PHY.
330 Currently supports the LAN83C185, LAN8187 and LAN8700 PHYs
333 tristate "STMicroelectronics STe10Xp PHYs"
335 This is the driver for the STe100p and STe101p PHYs.
337 config TERANETICS_PHY
338 tristate "Teranetics PHYs"
340 Currently supports the Teranetics TN2020
343 tristate "Vitesse PHYs"
345 Currently supports the vsc8244
347 config XILINX_GMII2RGMII
348 tristate "Xilinx GMII2RGMII converter driver"
350 This driver support xilinx GMII to RGMII IP core it provides
351 the Reduced Gigabit Media Independent Interface(RGMII) between
352 Ethernet physical media devices and the Gigabit Ethernet controller.
356 config MICREL_KS8995MA
357 tristate "Micrel KS8995MA 5-ports 10/100 managed Ethernet switch"