2 * include/linux/amba/mmci.h
7 #include <linux/mmc/host.h>
10 * struct mmci_platform_data - platform configuration for the MMCI
11 * (also known as PL180) block.
12 * @f_max: the maximum operational frequency for this host in this
13 * platform configuration. When this is specified it takes precedence
14 * over the module parameter for the same frequency.
15 * @ocr_mask: available voltages on the 4 pins from the block, this
16 * is ignored if a regulator is used, see the MMC_VDD_* masks in
18 * @vdd_handler: a callback function to translate a MMC_VDD_*
19 * mask into a value to be binary (or set some other custom bits
20 * in MMCIPWR) or:ed and written into the MMCIPWR register of the
21 * block. May also control external power based on the power_mode.
22 * @status: if no GPIO read function was given to the block in
23 * gpio_wp (below) this function will be called to determine
24 * whether a card is present in the MMC slot or not
25 * @gpio_wp: read this GPIO pin to see if the card is write protected
26 * @gpio_cd: read this GPIO pin to detect card insertion
27 * @cd_invert: true if the gpio_cd pin value is active low
28 * @capabilities: the capabilities of the block as implemented in
29 * this platform, signify anything MMC_CAP_* from mmc/host.h
31 struct mmci_platform_data {
33 unsigned int ocr_mask;
34 u32 (*vdd_handler)(struct device *, unsigned int vdd,
35 unsigned char power_mode);
36 unsigned int (*status)(struct device *);
40 unsigned long capabilities;