ARM: remove jadecpu board support

[karo-tx-uboot.git] / doc / README.fdt-control

diff --git a/doc/README.fdt-control b/doc/README.fdt-control
index 0ceebe7aa6f959fb901a21a45931ee245836eac7..d8fe4a826f20d41335067b6c3a251d1a12d4dfd8 100644 (file)
--- a/doc/README.fdt-control
+++ b/doc/README.fdt-control
@@ -122,7 +122,8 @@ This should include your CPU or SOC's device tree file, placed in
 arch/<arch>/dts, and then make any adjustments required.
 
 If CONFIG_OF_EMBED is defined, then it will be picked up and built into
 arch/<arch>/dts, and then make any adjustments required.
 
 If CONFIG_OF_EMBED is defined, then it will be picked up and built into

-the U-Boot image (including u-boot.bin).
+the U-Boot image (including u-boot.bin). This is suitable for debugging
+and development only and is not recommended for production devices.

 
 If CONFIG_OF_SEPARATE is defined, then it will be built and placed in
 a u-boot.dtb file alongside u-boot.bin. A common approach is then to
 
 If CONFIG_OF_SEPARATE is defined, then it will be built and placed in
 a u-boot.dtb file alongside u-boot.bin. A common approach is then to


@@ -130,7 +131,10 @@ join the two:
 
        cat u-boot.bin u-boot.dtb >image.bin
 
 
        cat u-boot.bin u-boot.dtb >image.bin
 

-and then flash image.bin onto your board.
+and then flash image.bin onto your board. Note that U-Boot creates
+u-boot-dtb.bin which does the above step for you also. If you are using
+CONFIG_SPL_FRAMEWORK, then u-boot.img will be built to include the device
+tree binary.

 
 If CONFIG_OF_HOSTFILE is defined, then it will be read from a file on
 startup. This is only useful for sandbox. Use the -d flag to U-Boot to
 
 If CONFIG_OF_HOSTFILE is defined, then it will be read from a file on
 startup. This is only useful for sandbox. Use the -d flag to U-Boot to


@@ -138,6 +142,14 @@ specify the file to read.
 
 You cannot use more than one of these options at the same time.
 
 
 You cannot use more than one of these options at the same time.
 

+To use a device tree file that you have compiled yourself, pass
+EXT_DTB=<filename> to 'make', as in:
+
+       make EXT_DTB=boot/am335x-boneblack-pubkey.dtb
+
+Then U-Boot will copy that file to u-boot.dtb, put it in the .img file
+if used, and u-boot-dtb.bin.
+

 If you wish to put the fdt at a different address in memory, you can
 define the "fdtcontroladdr" environment variable. This is the hex
 address of the fdt binary blob, and will override either of the options.
 If you wish to put the fdt at a different address in memory, you can
 define the "fdtcontroladdr" environment variable. This is the hex
 address of the fdt binary blob, and will override either of the options.