drm: fix wrong usages of drm_device in DRM Developer's Guide

[mv-sheeva.git] / Documentation / kernel-parameters.txt

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 5e4d9a65d550ddba2ead71966635f3380cdf57ff..89835a4766a684468695b430ac8e7e7f1b76dabc 100644 (file)
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -43,11 +43,11 @@ parameter is applicable:
        AVR32   AVR32 architecture is enabled.
        AX25    Appropriate AX.25 support is enabled.
        BLACKFIN Blackfin architecture is enabled.
+       DRM     Direct Rendering Management support is enabled.
+       DYNAMIC_DEBUG Build in debug messages and enable them at runtime
        EDD     BIOS Enhanced Disk Drive Services (EDD) is enabled
        EFI     EFI Partitioning (GPT) is enabled
        EIDE    EIDE/ATAPI support is enabled.
-       DRM     Direct Rendering Management support is enabled.
-       DYNAMIC_DEBUG Build in debug messages and enable them at runtime
        FB      The frame buffer device is enabled.
        GCOV    GCOV profiling is enabled.
        HW      Appropriate hardware is enabled.
@@ -199,11 +199,6 @@ and is between 256 and 4096 characters. It is defined in the file
                        unusable.  The "log_buf_len" parameter may be useful
                        if you need to capture more output.
 
-       acpi_display_output=    [HW,ACPI]
-                       acpi_display_output=vendor
-                       acpi_display_output=video
-                       See above.
-
        acpi_irq_balance [HW,ACPI]
                        ACPI will balance active IRQs
                        default in APIC mode
@@ -659,11 +654,6 @@ and is between 256 and 4096 characters. It is defined in the file
 
        dscc4.setup=    [NET]
 
-       dynamic_printk  Enables pr_debug()/dev_dbg() calls if
-                       CONFIG_DYNAMIC_PRINTK_DEBUG has been enabled.
-                       These can also be switched on/off via
-                       <debugfs>/dynamic_printk/modules
-
        earlycon=       [KNL] Output early console device and options.
                uart[8250],io,<addr>[,options]
                uart[8250],mmio,<addr>[,options]
@@ -1710,6 +1700,9 @@ and is between 256 and 4096 characters. It is defined in the file
 
        no-kvmclock     [X86,KVM] Disable paravirtualized KVM clock driver
 
+       no-kvmapf       [X86,KVM] Disable paravirtualized asynchronous page
+                       fault handling.
+
        nolapic         [X86-32,APIC] Do not enable or use the local APIC.
 
        nolapic_timer   [X86-32,APIC] Do not use the local APIC timer.