AVR32 AVR32 architecture is enabled.
AX25 Appropriate AX.25 support is enabled.
BLACKFIN Blackfin architecture is enabled.
+ DRM Direct Rendering Management support is enabled.
+ DYNAMIC_DEBUG Build in debug messages and enable them at runtime
EDD BIOS Enhanced Disk Drive Services (EDD) is enabled
EFI EFI Partitioning (GPT) is enabled
EIDE EIDE/ATAPI support is enabled.
- DRM Direct Rendering Management support is enabled.
- DYNAMIC_DEBUG Build in debug messages and enable them at runtime
FB The frame buffer device is enabled.
GCOV GCOV profiling is enabled.
HW Appropriate hardware is enabled.
and is between 256 and 4096 characters. It is defined in the file
./include/asm/setup.h as COMMAND_LINE_SIZE.
+Finally, the [KMG] suffix is commonly described after a number of kernel
+parameter values. These 'K', 'M', and 'G' letters represent the _binary_
+multipliers 'Kilo', 'Mega', and 'Giga', equalling 2^10, 2^20, and 2^30
+bytes respectively. Such letter suffixes can also be entirely omitted.
+
acpi= [HW,ACPI,X86]
Advanced Configuration and Power Interface
Format:
<first_slot>,<last_slot>,<port>,<enum_bit>[,<debug>]
- crashkernel=nn[KMG]@ss[KMG]
- [KNL] Reserve a chunk of physical memory to
- hold a kernel to switch to with kexec on panic.
+ crashkernel=size[KMG][@offset[KMG]]
+ [KNL] Using kexec, Linux can switch to a 'crash kernel'
+ upon panic. This parameter reserves the physical
+ memory region [offset, offset + size] for that kernel
+ image. If '@offset' is omitted, then a suitable offset
+ is selected automatically. Check
+ Documentation/kdump/kdump.txt for further details.
crashkernel=range1:size1[,range2:size2,...][@offset]
[KNL] Same as above, but depends on the memory
in the running system. The syntax of range is
start-[end] where start and end are both
a memory unit (amount[KMG]). See also
- Documentation/kdump/kdump.txt for a example.
+ Documentation/kdump/kdump.txt for an example.
cs89x0_dma= [HW,NET]
Format: <dma>
6 (KERN_INFO) informational
7 (KERN_DEBUG) debug-level messages
- log_buf_len=n Sets the size of the printk ring buffer, in bytes.
- Format: { n | nk | nM }
- n must be a power of two. The default size
- is set in the kernel config file.
+ log_buf_len=n[KMG] Sets the size of the printk ring buffer,
+ in bytes. n must be a power of two. The default
+ size is set in the kernel config file.
logo.nologo [FB] Disables display of the built-in Linux logo.
This may be used to provide more screen space for