---------------------------------------------------
For all supported boards there are ready-to-use default
-configurations available; just type "make <board_name>_config".
+configurations available; just type "make <board_name>_defconfig".
Example: For a TQM823L module type:
cd u-boot
- make TQM823L_config
+ make TQM823L_defconfig
For the Cogent platform, you need to specify the CPU type as well;
-e.g. "make cogent_mpc8xx_config". And also configure the cogent
+e.g. "make cogent_mpc8xx_defconfig". And also configure the cogent
directory according to the instructions in cogent/README.
CONFIG_SH_ETHER_CACHE_WRITEBACK
If this option is set, the driver enables cache flush.
+- PWM Support:
+ CONFIG_PWM_IMX
+ Support for PWM modul on the imx6.
+
- TPM Support:
CONFIG_TPM
Support TPM devices.
memories can be connected with a given cs line.
currently Xilinx Zynq qspi support these type of connections.
+ CONFIG_SYS_SPI_ST_ENABLE_WP_PIN
+ enable the W#/Vpp signal to disable writing to the status
+ register on ST MICRON flashes like the N25Q128.
+ The status register write enable/disable bit, combined with
+ the W#/VPP signal provides hardware data protection for the
+ device as follows: When the enable/disable bit is set to 1,
+ and the W#/VPP signal is driven LOW, the status register
+ nonvolatile bits become read-only and the WRITE STATUS REGISTER
+ operation will not execute. The only way to exit this
+ hardware-protected mode is to drive W#/VPP HIGH.
+
- SystemACE Support:
CONFIG_SYSTEMACE
sources you must configure U-Boot for one specific board type. This
is done by typing:
- make NAME_config
+ make NAME_defconfig
-where "NAME_config" is the name of one of the existing configu-
+where "NAME_defconfig" is the name of one of the existing configu-
rations; see boards.cfg for supported names.
Note: for some board special configuration names may exist; check if
or with LCD support. You can select such additional "features"
when choosing the configuration, i. e.
- make TQM823L_config
+ make TQM823L_defconfig
- will configure for a plain TQM823L, i. e. no LCD support
- make TQM823L_LCD_config
+ make TQM823L_LCD_defconfig
- will configure for a TQM823L with U-Boot console on LCD
etc.
1. Add O= to the make command line invocations:
make O=/tmp/build distclean
- make O=/tmp/build NAME_config
+ make O=/tmp/build NAME_defconfig
make O=/tmp/build all
2. Set environment variable BUILD_DIR to point to the desired location:
export BUILD_DIR=/tmp/build
make distclean
- make NAME_config
+ make NAME_defconfig
make all
Note that the command line "O=" setting overrides the BUILD_DIR environment
your board
3. If you're porting U-Boot to a new CPU, then also create a new
directory to hold your CPU specific code. Add any files you need.
-4. Run "make <board>_config" with your new name.
+4. Run "make <board>_defconfig" with your new name.
5. Type "make", and you should get a working "u-boot.srec" file
to be installed on your target system.
6. Debug and solve any problems that might arise.
Example:
- make TQM850L_config
+ make TQM850L_defconfig
make oldconfig
make dep
make uImage