CONFIG_SYS_FSL_DSP_CCSRBAR_DEFAULT
This value denotes start offset of DSP CCSR space.
+ CONFIG_SYS_FSL_SINGLE_SOURCE_CLK
+ Single Source Clock is clocking mode present in some of FSL SoC's.
+ In this mode, a single differential clock is used to supply
+ clocks to the sysclock, ddrclock and usbclock.
+
- Generic CPU options:
CONFIG_SYS_BIG_ENDIAN, CONFIG_SYS_LITTLE_ENDIAN
as a convenience, when switching between booting from
RAM and NFS.
+- Bootcount:
+ CONFIG_BOOTCOUNT_LIMIT
+ Implements a mechanism for detecting a repeating reboot
+ cycle, see:
+ http://www.denx.de/wiki/view/DULG/UBootBootCountLimit
+
+ CONFIG_BOOTCOUNT_ENV
+ If no softreset save registers are found on the hardware
+ "bootcount" is stored in the environment. To prevent a
+ saveenv on all reboots, the environment variable
+ "upgrade_available" is used. If "upgrade_available" is
+ 0, "bootcount" is always 0, if "upgrade_available" is
+ 1 "bootcount" is incremented in the environment.
+ So the Userspace Applikation must set the "upgrade_available"
+ and "bootcount" variable to 0, if a boot was successfully.
+
- Pre-Boot Commands:
CONFIG_PREBOOT
Defines the size and behavior of the NAND that SPL uses
to read U-Boot
+ CONFIG_SPL_NAND_BOOT
+ Add support NAND boot
+
CONFIG_SYS_NAND_U_BOOT_OFFS
Location in NAND to read U-Boot from
NOTE : currently only supported on AM335x platforms.
+- CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC:
+ Enables the RTC32K OSC on AM33xx based plattforms
+
Freescale QE/FMAN Firmware Support:
-----------------------------------
Load Address: 0x00000000
Entry Point: 0x00000000
+The "dumpimage" is a tool to disassemble images built by mkimage. Its "-i"
+option performs the converse operation of the mkimage's second form (the "-d"
+option). Given an image built by mkimage, the dumpimage extracts a "data file"
+from the image:
+
+ tools/dumpimage -i image -p position data_file
+ -i ==> extract from the 'image' a specific 'data_file', \
+ indexed by 'position'
+
Installing a Linux Image:
-------------------------