#include <mach/board.h>
#include <mach/at91sam9rl.h>
#include <mach/at91sam9rl_matrix.h>
+#include <mach/at91_matrix.h>
#include <mach/at91sam9_smc.h>
#include <mach/at_hdmac.h>
#if defined(CONFIG_AT_HDMAC) || defined(CONFIG_AT_HDMAC_MODULE)
static u64 hdmac_dmamask = DMA_BIT_MASK(32);
-static struct at_dma_platform_data atdma_pdata = {
- .nr_channels = 2,
-};
-
static struct resource hdmac_resources[] = {
[0] = {
- .start = AT91_BASE_SYS + AT91_DMA,
- .end = AT91_BASE_SYS + AT91_DMA + SZ_512 - 1,
+ .start = AT91SAM9RL_BASE_DMA,
+ .end = AT91SAM9RL_BASE_DMA + SZ_512 - 1,
.flags = IORESOURCE_MEM,
},
[2] = {
};
static struct platform_device at_hdmac_device = {
- .name = "at_hdmac",
+ .name = "at91sam9rl_dma",
.id = -1,
.dev = {
.dma_mask = &hdmac_dmamask,
.coherent_dma_mask = DMA_BIT_MASK(32),
- .platform_data = &atdma_pdata,
},
.resource = hdmac_resources,
.num_resources = ARRAY_SIZE(hdmac_resources),
void __init at91_add_device_hdmac(void)
{
- dma_cap_set(DMA_MEMCPY, atdma_pdata.cap_mask);
platform_device_register(&at_hdmac_device);
}
#else
usba_udc_data.pdata.num_ep = ARRAY_SIZE(usba_udc_ep);
memcpy(usba_udc_data.ep, usba_udc_ep, sizeof(usba_udc_ep));
- if (data && data->vbus_pin > 0) {
+ if (data && gpio_is_valid(data->vbus_pin)) {
at91_set_gpio_input(data->vbus_pin, 0);
at91_set_deglitch(data->vbus_pin, 1);
usba_udc_data.pdata.vbus_pin = data->vbus_pin;
return;
/* input/irq */
- if (data->det_pin) {
+ if (gpio_is_valid(data->det_pin)) {
at91_set_gpio_input(data->det_pin, 1);
at91_set_deglitch(data->det_pin, 1);
}
- if (data->wp_pin)
+ if (gpio_is_valid(data->wp_pin))
at91_set_gpio_input(data->wp_pin, 1);
- if (data->vcc_pin)
+ if (gpio_is_valid(data->vcc_pin))
at91_set_gpio_output(data->vcc_pin, 0);
/* CLK */
.flags = IORESOURCE_MEM,
},
[1] = {
- .start = AT91_BASE_SYS + AT91_ECC,
- .end = AT91_BASE_SYS + AT91_ECC + SZ_512 - 1,
+ .start = AT91SAM9RL_BASE_ECC,
+ .end = AT91SAM9RL_BASE_ECC + SZ_512 - 1,
.flags = IORESOURCE_MEM,
}
};
if (!data)
return;
- csa = at91_sys_read(AT91_MATRIX_EBICSA);
- at91_sys_write(AT91_MATRIX_EBICSA, csa | AT91_MATRIX_CS3A_SMC_SMARTMEDIA);
+ csa = at91_matrix_read(AT91_MATRIX_EBICSA);
+ at91_matrix_write(AT91_MATRIX_EBICSA, csa | AT91_MATRIX_CS3A_SMC_SMARTMEDIA);
/* enable pin */
- if (data->enable_pin)
+ if (gpio_is_valid(data->enable_pin))
at91_set_gpio_output(data->enable_pin, 1);
/* ready/busy pin */
- if (data->rdy_pin)
+ if (gpio_is_valid(data->rdy_pin))
at91_set_gpio_input(data->rdy_pin, 1);
/* card detect pin */
- if (data->det_pin)
+ if (gpio_is_valid(data->det_pin))
at91_set_gpio_input(data->det_pin, 1);
at91_set_A_periph(AT91_PIN_PB4, 0); /* NANDOE */
at91_set_A_periph(AT91_PIN_PD4, 0); /* AC97RX */
/* reset */
- if (data->reset_pin)
+ if (gpio_is_valid(data->reset_pin))
at91_set_gpio_output(data->reset_pin, 0);
ac97_data = *data;
static struct resource rtt_resources[] = {
{
- .start = AT91_BASE_SYS + AT91_RTT,
- .end = AT91_BASE_SYS + AT91_RTT + SZ_16 - 1,
+ .start = AT91SAM9RL_BASE_RTT,
+ .end = AT91SAM9RL_BASE_RTT + SZ_16 - 1,
+ .flags = IORESOURCE_MEM,
+ }, {
.flags = IORESOURCE_MEM,
}
};
.name = "at91_rtt",
.id = 0,
.resource = rtt_resources,
- .num_resources = ARRAY_SIZE(rtt_resources),
};
+#if IS_ENABLED(CONFIG_RTC_DRV_AT91SAM9)
+static void __init at91_add_device_rtt_rtc(void)
+{
+ at91sam9rl_rtt_device.name = "rtc-at91sam9";
+ /*
+ * The second resource is needed:
+ * GPBR will serve as the storage for RTC time offset
+ */
+ at91sam9rl_rtt_device.num_resources = 2;
+ rtt_resources[1].start = AT91SAM9RL_BASE_GPBR +
+ 4 * CONFIG_RTC_DRV_AT91SAM9_GPBR;
+ rtt_resources[1].end = rtt_resources[1].start + 3;
+}
+#else
+static void __init at91_add_device_rtt_rtc(void)
+{
+ /* Only one resource is needed: RTT not used as RTC */
+ at91sam9rl_rtt_device.num_resources = 1;
+}
+#endif
+
static void __init at91_add_device_rtt(void)
{
+ at91_add_device_rtt_rtc();
platform_device_register(&at91sam9rl_rtt_device);
}
* -------------------------------------------------------------------- */
#if defined(CONFIG_AT91SAM9X_WATCHDOG) || defined(CONFIG_AT91SAM9X_WATCHDOG_MODULE)
+static struct resource wdt_resources[] = {
+ {
+ .start = AT91SAM9RL_BASE_WDT,
+ .end = AT91SAM9RL_BASE_WDT + SZ_16 - 1,
+ .flags = IORESOURCE_MEM,
+ }
+};
+
static struct platform_device at91sam9rl_wdt_device = {
.name = "at91_wdt",
.id = -1,
- .num_resources = 0,
+ .resource = wdt_resources,
+ .num_resources = ARRAY_SIZE(wdt_resources),
};
static void __init at91_add_device_watchdog(void)
#if defined(CONFIG_SERIAL_ATMEL)
static struct resource dbgu_resources[] = {
[0] = {
- .start = AT91_BASE_SYS + AT91_DBGU,
- .end = AT91_BASE_SYS + AT91_DBGU + SZ_512 - 1,
+ .start = AT91SAM9RL_BASE_DBGU,
+ .end = AT91SAM9RL_BASE_DBGU + SZ_512 - 1,
.flags = IORESOURCE_MEM,
},
[1] = {
}
static struct platform_device *__initdata at91_uarts[ATMEL_MAX_UART]; /* the UARTs to use */
-struct platform_device *atmel_default_console_device; /* the serial console device */
void __init at91_register_uart(unsigned id, unsigned portnr, unsigned pins)
{