static void __init ek_add_device_dm9000(void)
{
/* Configure chip-select 2 (DM9000) */
- sam9_smc_configure(2, &dm9000_smc_config);
+ sam9_smc_configure(0, 2, &dm9000_smc_config);
/* Configure Reset signal as output */
at91_set_gpio_output(AT91_PIN_PC10, 0);
*/
static struct at91_usbh_data __initdata ek_usbh_data = {
.ports = 2,
+ .vbus_pin = {-EINVAL, -EINVAL},
+ .overcurrent_pin= {-EINVAL, -EINVAL},
};
*/
static struct at91_udc_data __initdata ek_udc_data = {
.vbus_pin = AT91_PIN_PB29,
- .pullup_pin = 0, /* pull-up driven by UDC */
+ .pullup_pin = -EINVAL, /* pull-up driven by UDC */
};
static struct atmel_nand_data __initdata ek_nand_data = {
.ale = 22,
.cle = 21,
-// .det_pin = ... not connected
+ .det_pin = -EINVAL,
.rdy_pin = AT91_PIN_PC15,
.enable_pin = AT91_PIN_PC14,
.parts = ek_nand_partition,
ek_nand_smc_config.mode |= AT91_SMC_DBW_8;
/* configure chip-select 3 (NAND) */
- sam9_smc_configure(3, &ek_nand_smc_config);
+ sam9_smc_configure(0, 3, &ek_nand_smc_config);
at91_add_device_nand(&ek_nand_data);
}
*/
static struct at91_mmc_data __initdata ek_mmc_data = {
.wire4 = 1,
+ .det_pin = -EINVAL,
+ .wp_pin = -EINVAL,
+ .vcc_pin = -EINVAL,
};
#endif /* CONFIG_SPI_ATMEL_* */