#include <asm/hardware.h>
#include <asm/io.h>
-#include <asm/arch/regs-serial.h>
+#include <asm/plat-s3c/regs-serial.h>
#include <asm/arch/regs-clock.h>
#include <asm/arch/regs-gpio.h>
#include <asm/arch/regs-mem.h>
return -EINVAL;
}
- if (state != PM_SUSPEND_MEM) {
- printk(KERN_ERR PFX "error: only PM_SUSPEND_MEM supported\n");
- return -EINVAL;
- }
-
/* check if we have anything to wake-up with... bad things seem
* to happen if you suspend with no wakeup (system will often
* require a full power-cycle)
__raw_writel(__raw_readl(S3C2410_INTPND), S3C2410_INTPND);
__raw_writel(__raw_readl(S3C2410_SRCPND), S3C2410_SRCPND);
- /* call cpu specific preperation */
+ /* call cpu specific preparation */
pm_cpu_prep();
return 0;
}
-/*
- * Called after processes are frozen, but before we shut down devices.
- */
-static int s3c2410_pm_prepare(suspend_state_t state)
-{
- return 0;
-}
-
-/*
- * Called after devices are re-setup, but before processes are thawed.
- */
-static int s3c2410_pm_finish(suspend_state_t state)
-{
- return 0;
-}
-
-/*
- * Set to PM_DISK_FIRMWARE so we can quickly veto suspend-to-disk.
- */
-static struct pm_ops s3c2410_pm_ops = {
- .pm_disk_mode = PM_DISK_FIRMWARE,
- .prepare = s3c2410_pm_prepare,
+static struct platform_suspend_ops s3c2410_pm_ops = {
.enter = s3c2410_pm_enter,
- .finish = s3c2410_pm_finish,
+ .valid = suspend_valid_only_mem,
};
/* s3c2410_pm_init
{
printk("S3C2410 Power Management, (c) 2004 Simtec Electronics\n");
- pm_set_ops(&s3c2410_pm_ops);
+ suspend_set_ops(&s3c2410_pm_ops);
return 0;
}