/*
- * arch/ppc64/kernel/head.S
- *
* PowerPC version
* Copyright (C) 1995-1996 Gary Thomas (gdt@linuxppc.org)
*
std r10,0(r1); /* make stack chain pointer */ \
std r0,GPR0(r1); /* save r0 in stackframe */ \
std r10,GPR1(r1); /* save r1 in stackframe */ \
+ ACCOUNT_CPU_USER_ENTRY(r9, r10); \
std r2,GPR2(r1); /* save r2 in stackframe */ \
SAVE_4GPRS(3, r1); /* save r3 - r6 in stackframe */ \
SAVE_2GPRS(7, r1); /* save r7, r8 in stackframe */ \
bl hdlr; \
b .ret_from_except
+/*
+ * Like STD_EXCEPTION_COMMON, but for exceptions that can occur
+ * in the idle task and therefore need the special idle handling.
+ */
+#define STD_EXCEPTION_COMMON_IDLE(trap, label, hdlr) \
+ .align 7; \
+ .globl label##_common; \
+label##_common: \
+ EXCEPTION_PROLOG_COMMON(trap, PACA_EXGEN); \
+ FINISH_NAP; \
+ DISABLE_INTS; \
+ bl .save_nvgprs; \
+ addi r3,r1,STACK_FRAME_OVERHEAD; \
+ bl hdlr; \
+ b .ret_from_except
+
#define STD_EXCEPTION_COMMON_LITE(trap, label, hdlr) \
.align 7; \
.globl label##_common; \
label##_common: \
EXCEPTION_PROLOG_COMMON(trap, PACA_EXGEN); \
+ FINISH_NAP; \
DISABLE_INTS; \
bl .ppc64_runlatch_on; \
addi r3,r1,STACK_FRAME_OVERHEAD; \
bl hdlr; \
b .ret_from_except_lite
+/*
+ * When the idle code in power4_idle puts the CPU into NAP mode,
+ * it has to do so in a loop, and relies on the external interrupt
+ * and decrementer interrupt entry code to get it out of the loop.
+ * It sets the _TLF_NAPPING bit in current_thread_info()->local_flags
+ * to signal that it is in the loop and needs help to get out.
+ */
+#ifdef CONFIG_PPC_970_NAP
+#define FINISH_NAP \
+BEGIN_FTR_SECTION \
+ clrrdi r11,r1,THREAD_SHIFT; \
+ ld r9,TI_LOCAL_FLAGS(r11); \
+ andi. r10,r9,_TLF_NAPPING; \
+ bnel power4_fixup_nap; \
+END_FTR_SECTION_IFSET(CPU_FTR_CAN_NAP)
+#else
+#define FINISH_NAP
+#endif
+
/*
* Start of pSeries system interrupt routines
*/
.globl machine_check_common
machine_check_common:
EXCEPTION_PROLOG_COMMON(0x200, PACA_EXMC)
+ FINISH_NAP
DISABLE_INTS
bl .save_nvgprs
addi r3,r1,STACK_FRAME_OVERHEAD
STD_EXCEPTION_COMMON(0xb00, trap_0b, .unknown_exception)
STD_EXCEPTION_COMMON(0xd00, single_step, .single_step_exception)
STD_EXCEPTION_COMMON(0xe00, trap_0e, .unknown_exception)
- STD_EXCEPTION_COMMON(0xf00, performance_monitor, .performance_monitor_exception)
+ STD_EXCEPTION_COMMON_IDLE(0xf00, performance_monitor, .performance_monitor_exception)
STD_EXCEPTION_COMMON(0x1300, instruction_breakpoint, .instruction_breakpoint_exception)
#ifdef CONFIG_ALTIVEC
STD_EXCEPTION_COMMON(0x1700, altivec_assist, .altivec_assist_exception)
ld r11,_NIP(r1)
andi. r3,r12,MSR_RI /* check if RI is set */
beq- unrecov_fer
+
+#ifdef CONFIG_VIRT_CPU_ACCOUNTING
+ andi. r3,r12,MSR_PR
+ beq 2f
+ ACCOUNT_CPU_USER_EXIT(r3, r4)
+2:
+#endif
+
ld r3,_CCR(r1)
ld r4,_LINK(r1)
ld r5,_CTR(r1)
.globl hardware_interrupt_entry
hardware_interrupt_common:
EXCEPTION_PROLOG_COMMON(0x500, PACA_EXGEN)
+ FINISH_NAP
hardware_interrupt_entry:
DISABLE_INTS
bl .ppc64_runlatch_on
bl .do_IRQ
b .ret_from_except_lite
+#ifdef CONFIG_PPC_970_NAP
+power4_fixup_nap:
+ andc r9,r9,r10
+ std r9,TI_LOCAL_FLAGS(r11)
+ ld r10,_LINK(r1) /* make idle task do the */
+ std r10,_NIP(r1) /* equivalent of a blr */
+ blr
+#endif
+
.align 7
.globl alignment_common
alignment_common:
mr r28,r6
mr r27,r7
+ /*
+ * Align the stack to 16-byte boundary
+ * Depending on the size and layout of the ELF sections in the initial
+ * boot binary, the stack pointer will be unalignet on PowerMac
+ */
+ rldicr r1,r1,0,59
+
/* Make sure we are running in 64 bits mode */
bl .enable_64b_mode
bl .__save_cpu_setup
sync
- /* Setup a valid physical PACA pointer in SPRG3 for early_setup
- * note that boot_cpuid can always be 0 nowadays since there is
- * nowhere it can be initialized differently before we reach this
- * code
- */
- LOAD_REG_IMMEDIATE(r27, boot_cpuid)
- add r27,r27,r26
- lwz r27,0(r27)
-
- LOAD_REG_IMMEDIATE(r24, paca) /* Get base vaddr of paca array */
- mulli r13,r27,PACA_SIZE /* Calculate vaddr of right paca */
- add r13,r13,r24 /* for this processor. */
- add r13,r13,r26 /* convert to physical addr */
- mtspr SPRN_SPRG3,r13
-
/* Do very early kernel initializations, including initial hash table,
* stab and slb setup before we turn on relocation. */
/* Not reached */
BUG_OPCODE
+/* Put the paca pointer into r13 and SPRG3 */
+_GLOBAL(setup_boot_paca)
+ LOAD_REG_IMMEDIATE(r3, boot_cpuid)
+ lwz r3,0(r3)
+ LOAD_REG_IMMEDIATE(r4, paca) /* Get base vaddr of paca array */
+ mulli r3,r3,PACA_SIZE /* Calculate vaddr of right paca */
+ add r13,r3,r4 /* for this processor. */
+ mtspr SPRN_SPRG3,r13
+
+ blr
+
/*
* We put a few things here that have to be page-aligned.
* This stuff goes at the beginning of the bss, which is page-aligned.