* There is no debug setup required for the cycles event.
* Note that only events in the same group can be used.
* Otherwise, there will be conflicts in correctly routing
- * the signals on the debug bus. It is the responsiblity
+ * the signals on the debug bus. It is the responsibility
* of the OProfile user tool to check the events are in
* the same group.
*/
* to a latch. The new values (interrupt setting bits, reset
* counter value etc.) are not copied to the actual registers
* until the performance monitor is enabled. In order to get
- * this to work as desired, the permormance monitor needs to
+ * this to work as desired, the performance monitor needs to
* be disabled while writing to the latches. This is a
* HW design issue.
*/
* to a latch. The new values (interrupt setting bits, reset
* counter value etc.) are not copied to the actual registers
* until the performance monitor is enabled. In order to get
- * this to work as desired, the permormance monitor needs to
+ * this to work as desired, the performance monitor needs to
* be disabled while writing to the latches. This is a
* HW design issue.
*/