-
/*
* (C) Copyright 2002
* Daniel Engström, Omicron Ceti AB, daniel@omicron.se
#define DEFINE_PCI_DEVICE_TABLE(_table) \
const struct pci_device_id _table[]
+struct pci_controller;
+
void pci_setup_type1(struct pci_controller *hose);
+
+/**
+ * board_pci_setup_hose() - Set up the PCI hose
+ *
+ * This is called by the common x86 PCI code to set up the PCI controller
+ * hose. It may be called when no memory/BSS is available so should just
+ * store things in 'hose' and not in BSS variables.
+ */
+void board_pci_setup_hose(struct pci_controller *hose);
+
+/**
+ * pci_early_init_hose() - Set up PCI host before relocation
+ *
+ * This allocates memory for, sets up and returns the PCI hose. It can be
+ * called before relocation. The hose will be stored in gd->hose for
+ * later use, but will become invalid one DRAM is available.
+ */
+int pci_early_init_hose(struct pci_controller **hosep);
+
+int board_pci_pre_scan(struct pci_controller *hose);
+int board_pci_post_scan(struct pci_controller *hose);
+
+/*
+ * Simple PCI access routines - these work from either the early PCI hose
+ * or the 'real' one, created after U-Boot has memory available
+ */
+unsigned int pci_read_config8(pci_dev_t dev, unsigned where);
+unsigned int pci_read_config16(pci_dev_t dev, unsigned where);
+unsigned int pci_read_config32(pci_dev_t dev, unsigned where);
+
+void pci_write_config8(pci_dev_t dev, unsigned where, unsigned value);
+void pci_write_config16(pci_dev_t dev, unsigned where, unsigned value);
+void pci_write_config32(pci_dev_t dev, unsigned where, unsigned value);
+
#endif