cd u-boot
tar -xjf /cdrom/U-Boot/u-boot-src.tar.bz2
+Alternatively you can access the current source via the git repository:
+git://git.karo-electronics.de/karo-tx-uboot.git master
+
+
Compiling U-Boot
----------------
export ARCH=arm
Environment variables:
-cpu_clk <CPU freq [MHz]>
-touchpanel {tsc2007|edt-ft5x06}
-otg_mode [host|device|none]
-video_mode <video mode as understood by Linux fb_find_mode() function>
- e.g.: 640x480MR-24@60
+cpu_clk <CPU freq [MHz]> CPU clock frequency set after boot.
+
+touchpanel {tsc2007|edt-ft5x06|am3359-tscadc} type of touchpanel.
+ No touchpanel will be enabled when unset.
+
+otg_mode [host|device|none] operation mode of the USBOTG port
+
+video_mode <one of the display names from the Glyn Family Concept or
+ a video mode as understood by Linux fb_find_mode() function
+ (e.g.: 640x480MR-24@60)>
+ LCD interface will be disabled when unset.
+
baseboard {stk5-v3|stk5-v5} selects type of baseboard
-splashimage memory address of a BMP file to be displayed instead of
- the built-in logo. Since NAND flash is not accessible in
- a memory mapped fashion, U-Boot will try to load the
- contents of the flash partition 'logo' to the address
- given with 'splashimage'.
+ 'stk5-v5' setting disables USB Host mode on USBOTG port
+ and redefines the LCD0 pin as CAN transceiver control pin.
+ Strings not starting in 'stk5' prevent the STK5 specific
+ pad initialization to be done.
+
+splashimage either: memory address (e.g. ${loadaddr}) of a BMP file
+ to be displayed instead of the built-in logo. Since NAND
+ flash is not accessible in a memory mapped fashion,
+ U-Boot will try to load the contents of the flash
+ partition 'logo.bmp' to the address given with
+ 'splashimage'.
+
+ or: the name of an MTD partition, that contains a raw
+ dump of the frame buffer contents which will be loaded
+ to the framebuffer.
+
+splashpos (when 'splashimage' contains a memory address) the
+ position ('x,y') on the screen at which the BMP image
+ will be displayed.
+ Setting splashpos to 'm,m' will center the image on the
+ screen.
Note: Some variables (like 'cpu_clk' or 'splashimage') may render the
board unbootable if incorrectly set. Therefore these variables
will not be evaluated in case the board has been reset through a
- watchdog reset or a character is available on the serial console
+ watchdog reset or <CTRL-C> is detected on the serial console
during startup to give the user a chance to recover from this
- situation.
+ situation. You should press and hold <CTRL-C> before applying
+ power to the module, for this to work.