Configuration Options:
+ CONFIG_SYS_NAND_U_BOOT_OFFS
+ NAND Offset from where SPL will read u-boot image. This is the starting
+ address of u-boot MTD partition in NAND.
+
CONFIG_CMD_NAND
Enables NAND support and commmands.
detection. However ECC calculation on such plaforms would still be
done by GPMC controller.
+ CONFIG_SPL_NAND_AM33XX_BCH
+ Enables SPL-NAND driver (am335x_spl_bch.c) which supports ELM based
+ hardware ECC correction. This is useful for platforms which have ELM
+ hardware engine and use NAND boot mode.
+ Some legacy platforms like OMAP3xx do not have in-built ELM h/w engine,
+ so those platforms should use CONFIG_SPL_NAND_SIMPLE for enabling
+ SPL-NAND driver with software ECC correction support.
+
CONFIG_NAND_OMAP_ECCSCHEME
On OMAP platforms, this CONFIG specifies NAND ECC scheme.
It can take following values:
Thus BCH16 can be supported on 4K page NAND.
+ CONFIG_NAND_OMAP_GPMC_PREFETCH
+ On OMAP platforms that use the GPMC controller
+ (CONFIG_NAND_OMAP_GPMC_PREFETCH), this options enables the code that
+ uses the prefetch mode to speed up read operations.
+
NOTE:
=====