* (C) Copyright 2001
* Denis Peter, MPL AG Switzerland
*
- * See file CREDITS for list of people who contributed to this
- * project.
- *
- * This program is free software; you can redistribute it and/or
- * modify it under the terms of the GNU General Public License as
- * published by the Free Software Foundation; either version 2 of
- * the License, or (at your option) any later version.
- *
- * This program is distributed in the hope that it will be useful,
- * but WITHOUT ANY WARRANTY; without even the implied warranty of
- * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
- * GNU General Public License for more details.
- *
- * You should have received a copy of the GNU General Public License
- * along with this program; if not, write to the Free Software
- * Foundation, Inc., 59 Temple Place, Suite 330, Boston,
- * MA 02111-1307 USA
- *
+ * SPDX-License-Identifier: GPL-2.0+
*/
USB Support for PIP405 and MIP405 (UHCI)
Storage USB Commands:
- usb scan: scans the USB for storage devices.The USB must be
running for this command (usb start)
-- usb device [dev]: show or set current USB staorage device
+- usb device [dev]: show or set current USB storage device
- usb part [dev]: print partition table of one or all USB storage
devices
- usb read addr blk# cnt:
support USB with CONFIG_CMD_USB enabled and working. You will need to
add some config settings to your board header file:
+#define CONFIG_CMD_USB /* the 'usb' interactive command */
#define CONFIG_USB_HOST_ETHER /* Enable USB Ethernet adapters */
-#define CONFIG_USB_ETHER_ASIX /* Asix, or whatever driver(s) you want */
+
+and one or more of the following for individual adapter hardware:
+
+#define CONFIG_USB_ETHER_ASIX
+#define CONFIG_USB_ETHER_MCS7830
+#define CONFIG_USB_ETHER_SMSC95XX
As with built-in networking, you will also want to enable some network
commands, for example:
#define CONFIG_CMD_NET
-#define CONFIG_NET_MULTI
#define CONFIG_CMD_PING
#define CONFIG_CMD_DHCP
You can also set the default IP address of your board and the server
as well as the default file to load when a 'bootp' command is issued.
-All of these can be obtained from the bootp server if not set.
+However note that encoding these individual network settings into a
+common exectuable is discouraged, as it leads to potential conflicts,
+and all the parameters can either get stored in the board's external
+environment, or get obtained from the bootp server if not set.
#define CONFIG_IPADDR 10.0.0.2 (replace with your value)
#define CONFIG_SERVERIP 10.0.0.1 (replace with your value)
-#define CONFIG_BOOTFILE uImage
+#define CONFIG_BOOTFILE "uImage"
The 'usb start' command should identify the adapter something like this: