struct nvbios *bios = &dev_priv->vbios;
unsigned int outputset = (dcbent->or == 4) ? 1 : 0;
uint16_t scriptptr = 0, clktable;
- uint8_t clktableptr = 0;
/*
* For now we assume version 3.0 table - g80 support will need some
scriptptr = ROM16(bios->data[bios->fp.lvdsmanufacturerpointer + 11 + outputset * 2]);
break;
case LVDS_RESET:
+ clktable = bios->fp.lvdsmanufacturerpointer + 15;
+ if (dcbent->or == 4)
+ clktable += 8;
+
if (dcbent->lvdsconf.use_straps_for_mode) {
if (bios->fp.dual_link)
- clktableptr += 2;
- if (bios->fp.BITbit1)
- clktableptr++;
+ clktable += 4;
+ if (bios->fp.if_is_24bit)
+ clktable += 2;
} else {
/* using EDID */
- uint8_t fallback = bios->data[bios->fp.lvdsmanufacturerpointer + 4];
- int fallbackcmpval = (dcbent->or == 4) ? 4 : 1;
+ int cmpval_24bit = (dcbent->or == 4) ? 4 : 1;
if (bios->fp.dual_link) {
- clktableptr += 2;
- fallbackcmpval *= 2;
+ clktable += 4;
+ cmpval_24bit <<= 1;
}
- if (fallbackcmpval & fallback)
- clktableptr++;
+
+ if (bios->fp.strapless_is_24bit & cmpval_24bit)
+ clktable += 2;
}
- /* adding outputset * 8 may not be correct */
- clktable = ROM16(bios->data[bios->fp.lvdsmanufacturerpointer + 15 + clktableptr * 2 + outputset * 8]);
+ clktable = ROM16(bios->data[clktable]);
if (!clktable) {
NV_ERROR(dev, "Pixel clock comparison table not found\n");
return -ENOENT;
* at which modes should be set up in the dual link style.
*
* Following the header, the BMP (ver 0xa) table has several records,
- * indexed by a seperate xlat table, indexed in turn by the fp strap in
+ * indexed by a separate xlat table, indexed in turn by the fp strap in
* EXTDEV_BOOT. Each record had a config byte, followed by 6 script
* numbers for use by INIT_SUB which controlled panel init and power,
* and finally a dword of ms to sleep between power off and on
*if_is_24bit = bios->data[lvdsofs] & 16;
break;
case 0x30:
- /*
- * My money would be on there being a 24 bit interface bit in
- * this table, but I have no example of a laptop bios with a
- * 24 bit panel to confirm that. Hence we shout loudly if any
- * bit other than bit 0 is set (I've not even seen bit 1)
- */
- if (bios->data[lvdsofs] > 1)
- NV_ERROR(dev,
- "You have a very unusual laptop display; please report it\n");
+ case 0x40:
/*
* No sign of the "power off for reset" or "reset for panel
* on" bits, but it's safer to assume we should
*/
bios->fp.power_off_for_reset = true;
bios->fp.reset_after_pclk_change = true;
+
/*
* It's ok lvdsofs is wrong for nv4x edid case; dual_link is
- * over-written, and BITbit1 isn't used
+ * over-written, and if_is_24bit isn't used
*/
bios->fp.dual_link = bios->data[lvdsofs] & 1;
- bios->fp.BITbit1 = bios->data[lvdsofs] & 2;
- bios->fp.duallink_transition_clk = ROM16(bios->data[bios->fp.lvdsmanufacturerpointer + 5]) * 10;
- break;
- case 0x40:
- bios->fp.dual_link = bios->data[lvdsofs] & 1;
bios->fp.if_is_24bit = bios->data[lvdsofs] & 2;
bios->fp.strapless_is_24bit = bios->data[bios->fp.lvdsmanufacturerpointer + 4];
bios->fp.duallink_transition_clk = ROM16(bios->data[bios->fp.lvdsmanufacturerpointer + 5]) * 10;
return type;
}
+static void
+apply_dcb_connector_quirks(struct nvbios *bios, int idx)
+{
+ struct dcb_connector_table_entry *cte = &bios->dcb.connector.entry[idx];
+ struct drm_device *dev = bios->dev;
+
+ /* Gigabyte NX85T */
+ if ((dev->pdev->device == 0x0421) &&
+ (dev->pdev->subsystem_vendor == 0x1458) &&
+ (dev->pdev->subsystem_device == 0x344c)) {
+ if (cte->type == DCB_CONNECTOR_HDMI_1)
+ cte->type = DCB_CONNECTOR_DVI_I;
+ }
+}
+
static void
parse_dcb_connector_table(struct nvbios *bios)
{
entry = conntab + conntab[1];
cte = &ct->entry[0];
for (i = 0; i < conntab[2]; i++, entry += conntab[3], cte++) {
+ cte->index = i;
if (conntab[3] == 2)
cte->entry = ROM16(entry[0]);
else
cte->entry = ROM32(entry[0]);
cte->type = (cte->entry & 0x000000ff) >> 0;
- cte->index = (cte->entry & 0x00000f00) >> 8;
+ cte->index2 = (cte->entry & 0x00000f00) >> 8;
switch (cte->entry & 0x00033000) {
case 0x00001000:
cte->gpio_tag = 0x07;
if (cte->type == 0xff)
continue;
+ apply_dcb_connector_quirks(bios, i);
+
NV_INFO(dev, " %d: 0x%08x: type 0x%02x idx %d tag 0x%02x\n",
i, cte->entry, cte->type, cte->index, cte->gpio_tag);
break;
default:
cte->type = divine_connector_type(bios, cte->index);
- NV_WARN(dev, "unknown type, using 0x%02x", cte->type);
+ NV_WARN(dev, "unknown type, using 0x%02x\n", cte->type);
break;
}
+ if (nouveau_override_conntype) {
+ int type = divine_connector_type(bios, cte->index);
+ if (type != cte->type)
+ NV_WARN(dev, " -> type 0x%02x\n", cte->type);
+ }
+
}
}