* Current RAID-1,4,5 parallel reconstruction 'guaranteed speed limit'
* is 1000 KB/sec, so the extra system load does not show up that much.
* Increase it if you want to have more _guaranteed_ speed. Note that
- * the RAID driver will use the maximum available bandwith if the IO
+ * the RAID driver will use the maximum available bandwidth if the IO
* subsystem is idle. There is also an 'absolute maximum' reconstruction
* speed limit - in case reconstruction slows down your system despite
* idle IO detection.
* many dirty RAID5 blocks.
*/
+ allow_signal(SIGKILL);
complete(thread->event);
while (!kthread_should_stop()) {
void (*run)(mddev_t *);
thread->mddev = mddev;
thread->name = name;
thread->timeout = MAX_SCHEDULE_TIMEOUT;
- thread->tsk = kthread_run(md_thread, thread, mdname(thread->mddev));
+ thread->tsk = kthread_run(md_thread, thread, name, mdname(thread->mddev));
if (IS_ERR(thread->tsk)) {
kfree(thread);
return NULL;
idle = 1;
ITERATE_RDEV(mddev,rdev,tmp) {
struct gendisk *disk = rdev->bdev->bd_contains->bd_disk;
- curr_events = disk_stat_read(disk, read_sectors) +
- disk_stat_read(disk, write_sectors) -
+ curr_events = disk_stat_read(disk, sectors[0]) +
+ disk_stat_read(disk, sectors[1]) -
atomic_read(&disk->sync_io);
/* Allow some slack between valud of curr_events and last_events,
* as there are some uninteresting races.
mddev->curr_resync = 2;
try_again:
- if (signal_pending(current)) {
+ if (signal_pending(current) ||
+ kthread_should_stop()) {
flush_signals(current);
+ set_bit(MD_RECOVERY_INTR, &mddev->recovery);
goto skip;
}
ITERATE_MDDEV(mddev2,tmp) {
*/
continue;
prepare_to_wait(&resync_wait, &wq, TASK_INTERRUPTIBLE);
- if (!signal_pending(current)
- && mddev2->curr_resync >= mddev->curr_resync) {
+ if (!signal_pending(current) &&
+ !kthread_should_stop() &&
+ mddev2->curr_resync >= mddev->curr_resync) {
printk(KERN_INFO "md: delaying resync of %s"
" until %s has finished resync (they"
" share one or more physical units)\n",
printk(KERN_INFO "md: syncing RAID array %s\n", mdname(mddev));
printk(KERN_INFO "md: minimum _guaranteed_ reconstruction speed:"
" %d KB/sec/disc.\n", sysctl_speed_limit_min);
- printk(KERN_INFO "md: using maximum available idle IO bandwith "
+ printk(KERN_INFO "md: using maximum available idle IO bandwidth "
"(but not more than %d KB/sec) for reconstruction.\n",
sysctl_speed_limit_max);
}
- if (signal_pending(current)) {
+ if (signal_pending(current) || kthread_should_stop()) {
/*
* got a signal, exit.
*/