config MTD_PHYSMAP_LEN
hex "Physical length of flash mapping"
depends on MTD_PHYSMAP
- default "0x4000000"
+ default "0"
help
This is the total length of the mapping of the flash chips on
your particular board. If there is space, or aliases, in the
config MTD_SUN_UFLASH
tristate "Sun Microsystems userflash support"
- depends on (SPARC32 || SPARC64) && MTD_CFI
+ depends on SPARC && MTD_CFI
help
This provides a 'mapping' driver which supports the way in
which user-programmable flash chips are connected on various
config MTD_SC520CDP
tristate "CFI Flash device mapped on AMD SC520 CDP"
- depends on X86 && MTD_CFI
+ depends on X86 && MTD_CFI && MTD_CONCAT
help
The SC520 CDP board has two banks of CFI-compliant chips and one
Dual-in-line JEDEC chip. This 'mapping' driver supports that
mtd1 allows you to reprogram your BIOS. BE VERY CAREFUL.
Note that jumper 3 ("Write Enable Drive A") must be set
- otherwise detection won't succeeed.
+ otherwise detection won't succeed.
config MTD_SBC_GXX
tristate "CFI Flash device mapped on Arcom SBC-GXx boards"
Support for the flash chip on Tsunami TIG bus.
config MTD_LASAT
- tristate "Flash chips on LASAT board"
- depends on LASAT
+ tristate "LASAT flash device"
+ depends on LASAT && MTD_CFI
help
Support for the flash chips on the Lasat 100 and 200 boards.
IXDP425 and Coyote. If you have an IXP2000 based board and
would like to use the flash chips on it, say 'Y'.
-config MTD_EPXA10DB
- tristate "CFI Flash device mapped on Epxa10db"
- depends on MTD_CFI && MTD_PARTITIONS && ARCH_CAMELOT
- help
- This enables support for the flash devices on the Altera
- Excalibur XA10 Development Board. If you are building a kernel
- for on of these boards then you should say 'Y' otherwise say 'N'.
-
config MTD_FORTUNET
tristate "CFI Flash device mapped on the FortuNet board"
depends on MTD_CFI && MTD_PARTITIONS && SA1100_FORTUNET
This enables access to the flash chips on the Interface MPC-1211(CTP/PCI/MPC-SH02).
If you have such a board, say 'Y'.
-config MTD_PQ2FADS
- tristate "JEDEC flash SIMM mapped on PQ2FADS and 8272ADS boards"
- depends on (ADS8272 || PQ2FADS) && MTD_PARTITIONS && MTD_JEDECPROBE && MTD_PHYSMAP && MTD_CFI_GEOMETRY && MTD_CFI_INTELEXT
- help
- This enables access to flash SIMM on PQ2FADS-like boards
-
config MTD_OMAP_NOR
tristate "TI OMAP board mappings"
depends on MTD_CFI && ARCH_OMAP
config MTD_PCMCIA_ANONYMOUS
bool "Use PCMCIA MTD drivers for anonymous PCMCIA cards"
depends on MTD_PCMCIA
- default N
help
If this option is enabled, PCMCIA cards which do not report
anything about themselves are assumed to be MTD cards.