/* The cs8900 has 4 IRQ pins, software selectable. cs8900_irq_map maps
them to system IRQ numbers. This mapping is card specific and is set to
the configuration of the Cirrus Eval board for this chip. */
-#ifdef CONFIG_ARCH_CLPS7500
-static unsigned int netcard_portlist[] __used __initdata =
- { 0x80090303, 0x300, 0x320, 0x340, 0x360, 0x200, 0x220, 0x240, 0x260, 0x280, 0x2a0, 0x2c0, 0x2e0, 0};
-static unsigned int cs8900_irq_map[] = {12,0,0,0};
-#elif defined(CONFIG_SH_HICOSH4)
+#if defined(CONFIG_SH_HICOSH4)
static unsigned int netcard_portlist[] __used __initdata =
{ 0x0300, 0};
static unsigned int cs8900_irq_map[] = {1,0,0,0};
}
#endif
+static const struct net_device_ops net_ops = {
+ .ndo_open = net_open,
+ .ndo_stop = net_close,
+ .ndo_tx_timeout = net_timeout,
+ .ndo_start_xmit = net_send_packet,
+ .ndo_get_stats = net_get_stats,
+ .ndo_set_multicast_list = set_multicast_list,
+ .ndo_set_mac_address = set_mac_address,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = net_poll_controller,
+#endif
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_validate_addr = eth_validate_addr,
+};
+
/* This is the real probe routine. Linux has a history of friendly device
probes on the ISA bus. A good device probes avoids doing writes, and
verifies that the correct device exists and functions.
unsigned rev_type = 0;
int eeprom_buff[CHKSUM_LEN];
int retval;
- DECLARE_MAC_BUF(mac);
/* Initialize the device structure. */
if (!modular) {
}
/* print the ethernet address. */
- printk(", MAC %s", print_mac(mac, dev->dev_addr));
-
- dev->open = net_open;
- dev->stop = net_close;
- dev->tx_timeout = net_timeout;
- dev->watchdog_timeo = HZ;
- dev->hard_start_xmit = net_send_packet;
- dev->get_stats = net_get_stats;
- dev->set_multicast_list = set_multicast_list;
- dev->set_mac_address = set_mac_address;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = net_poll_controller;
-#endif
+ printk(", MAC %pM", dev->dev_addr);
+
+ dev->netdev_ops = &net_ops;
+ dev->watchdog_timeo = HZ;
printk("\n");
if (net_debug)
}
skb->protocol=eth_type_trans(skb,dev);
netif_rx(skb);
- dev->last_rx = jiffies;
lp->stats.rx_packets++;
lp->stats.rx_bytes += length;
}
#endif /* ALLOW_DMA */
-void __init reset_chip(struct net_device *dev)
+static void __init reset_chip(struct net_device *dev)
{
#if !defined(CONFIG_MACH_MX31ADS)
#if !defined(CONFIG_MACH_IXDP2351) && !defined(CONFIG_ARCH_IXDP2X01)
skb->protocol=eth_type_trans(skb,dev);
netif_rx(skb);
- dev->last_rx = jiffies;
lp->stats.rx_packets++;
lp->stats.rx_bytes += length;
}
memcpy(dev->dev_addr, addr->sa_data, dev->addr_len);
- if (net_debug) {
- DECLARE_MAC_BUF(mac);
- printk("%s: Setting MAC address to %s.\n",
- dev->name, print_mac(mac, dev->dev_addr));
- }
+ if (net_debug)
+ printk("%s: Setting MAC address to %pM.\n",
+ dev->name, dev->dev_addr);
+
/* set the Ethernet address */
for (i=0; i < ETH_ALEN/2; i++)
writereg(dev, PP_IA+i*2, dev->dev_addr[i*2] | (dev->dev_addr[i*2+1] << 8));