/* The cs8900 has 4 IRQ pins, software selectable. cs8900_irq_map maps
them to system IRQ numbers. This mapping is card specific and is set to
the configuration of the Cirrus Eval board for this chip. */
-#ifdef CONFIG_ARCH_CLPS7500
-static unsigned int netcard_portlist[] __used __initdata =
- { 0x80090303, 0x300, 0x320, 0x340, 0x360, 0x200, 0x220, 0x240, 0x260, 0x280, 0x2a0, 0x2c0, 0x2e0, 0};
-static unsigned int cs8900_irq_map[] = {12,0,0,0};
-#elif defined(CONFIG_SH_HICOSH4)
+#if defined(CONFIG_SH_HICOSH4)
static unsigned int netcard_portlist[] __used __initdata =
{ 0x0300, 0};
static unsigned int cs8900_irq_map[] = {1,0,0,0};
}
#endif
+static const struct net_device_ops net_ops = {
+ .ndo_open = net_open,
+ .ndo_stop = net_close,
+ .ndo_tx_timeout = net_timeout,
+ .ndo_start_xmit = net_send_packet,
+ .ndo_get_stats = net_get_stats,
+ .ndo_set_multicast_list = set_multicast_list,
+ .ndo_set_mac_address = set_mac_address,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = net_poll_controller,
+#endif
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_validate_addr = eth_validate_addr,
+};
+
/* This is the real probe routine. Linux has a history of friendly device
probes on the ISA bus. A good device probes avoids doing writes, and
verifies that the correct device exists and functions.
/* print the ethernet address. */
printk(", MAC %pM", dev->dev_addr);
- dev->open = net_open;
- dev->stop = net_close;
- dev->tx_timeout = net_timeout;
- dev->watchdog_timeo = HZ;
- dev->hard_start_xmit = net_send_packet;
- dev->get_stats = net_get_stats;
- dev->set_multicast_list = set_multicast_list;
- dev->set_mac_address = set_mac_address;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = net_poll_controller;
-#endif
+ dev->netdev_ops = &net_ops;
+ dev->watchdog_timeo = HZ;
printk("\n");
if (net_debug)