}
/**
- * e1000e_get_speed_and_duplex_copper - Retreive current speed/duplex
+ * e1000e_get_speed_and_duplex_copper - Retrieve current speed/duplex
* @hw: pointer to the HW structure
* @speed: stores the current speed
* @duplex: stores the current duplex
}
/**
- * e1000e_get_speed_and_duplex_fiber_serdes - Retreive current speed/duplex
+ * e1000e_get_speed_and_duplex_fiber_serdes - Retrieve current speed/duplex
* @hw: pointer to the HW structure
* @speed: stores the current speed
* @duplex: stores the current duplex
* e1000e_blink_led - Blink LED
* @hw: pointer to the HW structure
*
- * Blink the led's which are set to be on.
+ * Blink the LEDs which are set to be on.
**/
s32 e1000e_blink_led(struct e1000_hw *hw)
{
* @hw: pointer to the HW structure
*
* Returns 0 if successful, else returns -10
- * (-E1000_ERR_MASTER_REQUESTS_PENDING) if master disable bit has not casued
+ * (-E1000_ERR_MASTER_REQUESTS_PENDING) if master disable bit has not caused
* the master requests to be disabled.
*
* Disables PCI-Express master access and verifies there are no pending
}
/**
- * e1000e_read_nvm_spi - Read EEPROM's using SPI
+ * e1000e_read_nvm_spi - Reads EEPROM using SPI
* @hw: pointer to the HW structure
* @offset: offset of word in the EEPROM to read
* @words: number of words to read
* Writes data to EEPROM at offset using SPI interface.
*
* If e1000e_update_nvm_checksum is not called after this function , the
- * EEPROM will most likley contain an invalid checksum.
+ * EEPROM will most likely contain an invalid checksum.
**/
s32 e1000e_write_nvm_spi(struct e1000_hw *hw, u16 offset, u16 words, u16 *data)
{
*
* Returns E1000_success upon success, else E1000_ERR_HOST_INTERFACE_COMMAND
*
- * This function checks whether the HOST IF is enabled for command operaton
+ * This function checks whether the HOST IF is enabled for command operation
* and also checks whether the previous command is completed. It busy waits
* in case of previous command is not completed.
**/
}
/**
- * e1000e_check_mng_mode - check managament mode
+ * e1000e_check_mng_mode - check management mode
* @hw: pointer to the HW structure
*
* Reads the firmware semaphore register and returns true (>0) if