static void __init printEEPROMInfo(struct net_device *dev)
{
- struct eepro_local *lp = (struct eepro_local *)dev->priv;
+ struct eepro_local *lp = netdev_priv(dev);
int ioaddr = dev->base_addr;
unsigned short Word;
int i,j;
static const struct ethtool_ops eepro_ethtool_ops;
+static const struct net_device_ops eepro_netdev_ops = {
+ .ndo_open = eepro_open,
+ .ndo_stop = eepro_close,
+ .ndo_start_xmit = eepro_send_packet,
+ .ndo_set_multicast_list = set_multicast_list,
+ .ndo_tx_timeout = eepro_tx_timeout,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_validate_addr = eth_validate_addr,
+};
+
/* This is the real probe routine. Linux has a history of friendly device
probes on the ISA bus. A good device probe avoids doing writes, and
verifies that the correct device exists and functions. */
}
}
- dev->open = eepro_open;
- dev->stop = eepro_close;
- dev->hard_start_xmit = eepro_send_packet;
- dev->set_multicast_list = &set_multicast_list;
- dev->tx_timeout = eepro_tx_timeout;
+ dev->netdev_ops = &eepro_netdev_ops;
dev->watchdog_timeo = TX_TIMEOUT;
dev->ethtool_ops = &eepro_ethtool_ops;
#define eeprom_delay() { udelay(40); }
#define EE_READ_CMD (6 << 6)
-int
+static int
read_eeprom(int ioaddr, int location, struct net_device *dev)
{
int i;
static int eepro_ethtool_get_settings(struct net_device *dev,
struct ethtool_cmd *cmd)
{
- struct eepro_local *lp = (struct eepro_local *)dev->priv;
+ struct eepro_local *lp = netdev_priv(dev);
cmd->supported = SUPPORTED_10baseT_Half |
SUPPORTED_10baseT_Full |