fmc_tx_port_graceful_stop_disable(fm_eth);
#ifdef CONFIG_PHYLIB
- ret = phy_startup(fm_eth->phydev);
- if (ret) {
- printf("%s: Could not initialize\n", fm_eth->phydev->dev->name);
- return ret;
+ if (fm_eth->phydev) {
+ ret = phy_startup(fm_eth->phydev);
+ if (ret) {
+ printf("%s: Could not initialize\n",
+ fm_eth->phydev->dev->name);
+ return ret;
+ }
+ } else {
+ return 0;
}
#else
fm_eth->phydev->speed = SPEED_1000;
/* disable bmi Rx port */
bmi_rx_port_disable(fm_eth->rx_port);
- phy_shutdown(fm_eth->phydev);
+ if (fm_eth->phydev)
+ phy_shutdown(fm_eth->phydev);
}
static int fm_eth_send(struct eth_device *dev, void *buf, int len)
if (!(status & RxBD_ERROR)) {
data = (u8 *)rxbd->buf_ptr_lo;
len = rxbd->len;
- NetReceive(data, len);
+ net_process_received_packet(data, len);
} else {
printf("%s: Rx error\n", dev->name);
return 0;
num = fm_eth->num;
#ifdef CONFIG_SYS_FMAN_V3
+#ifndef CONFIG_FSL_FM_10GEC_REGULAR_NOTATION
if (fm_eth->type == FM_ETH_10G_E) {
- /* 10GEC1/10GEC2 use mEMAC9/mEMAC10
- * 10GEC3/10GEC4 use mEMAC1/mEMAC2
+ /* 10GEC1/10GEC2 use mEMAC9/mEMAC10 on T2080/T4240.
+ * 10GEC3/10GEC4 use mEMAC1/mEMAC2 on T2080.
+ * 10GEC1 uses mEMAC1 on T1024.
* so it needs to change the num.
*/
if (fm_eth->num >= 2)
else
num += 8;
}
+#endif
base = ®->memac[num].fm_memac;
phyregs = ®->memac[num].fm_memac_mdio;
#else
if (fm_eth->bus) {
phydev = phy_connect(fm_eth->bus, fm_eth->phyaddr, dev,
fm_eth->enet_if);
- }
-
- if (!phydev) {
- printf("Failed to connect\n");
- return -1;
+ if (!phydev) {
+ printf("Failed to connect\n");
+ return -1;
+ }
+ } else {
+ return 0;
}
if (fm_eth->type == FM_ETH_1G_E) {
if (!fm_eth_startup(fm_eth))
return 0;
- if (init_phy(dev))
- return 0;
+ init_phy(dev);
/* clear the ethernet address */
for (i = 0; i < 6; i++)