mutex_unlock(&priv->mutex);
}
-static int iwl3945_mac_config(struct ieee80211_hw *hw, u32 changed);
-
#define IWL_DELAY_NEXT_SCAN (HZ*2)
void iwl3945_post_associate(struct iwl_priv *priv)
return NETDEV_TX_OK;
}
-/**
- * iwl3945_mac_config - mac80211 config callback
- *
- * We ignore conf->flags & IEEE80211_CONF_SHORT_SLOT_TIME since it seems to
- * be set inappropriately and the driver currently sets the hardware up to
- * use it whenever needed.
- */
-static int iwl3945_mac_config(struct ieee80211_hw *hw, u32 changed)
-{
- struct iwl_priv *priv = hw->priv;
- const struct iwl_channel_info *ch_info;
- struct ieee80211_conf *conf = &hw->conf;
- unsigned long flags;
- int ret = 0;
-
- mutex_lock(&priv->mutex);
- IWL_DEBUG_MAC80211(priv, "enter to channel %d\n",
- conf->channel->hw_value);
-
- if (!iwl_is_ready(priv)) {
- IWL_DEBUG_MAC80211(priv, "leave - not ready\n");
- ret = -EIO;
- goto out;
- }
-
- if (unlikely(!iwl3945_mod_params.disable_hw_scan &&
- test_bit(STATUS_SCANNING, &priv->status))) {
- IWL_DEBUG_MAC80211(priv, "leave - scanning\n");
- set_bit(STATUS_CONF_PENDING, &priv->status);
- mutex_unlock(&priv->mutex);
- return 0;
- }
-
- spin_lock_irqsave(&priv->lock, flags);
-
- ch_info = iwl_get_channel_info(priv, conf->channel->band,
- conf->channel->hw_value);
- if (!is_channel_valid(ch_info)) {
- IWL_DEBUG_SCAN(priv,
- "Channel %d [%d] is INVALID for this band.\n",
- conf->channel->hw_value, conf->channel->band);
- IWL_DEBUG_MAC80211(priv, "leave - invalid channel\n");
- spin_unlock_irqrestore(&priv->lock, flags);
- ret = -EINVAL;
- goto out;
- }
-
- iwl_set_rxon_channel(priv, conf->channel);
-
- iwl_set_flags_for_band(priv, conf->channel->band);
-
- /* The list of supported rates and rate mask can be different
- * for each phymode; since the phymode may have changed, reset
- * the rate mask to what mac80211 lists */
- iwl_set_rate(priv);
-
- spin_unlock_irqrestore(&priv->lock, flags);
-
-#ifdef IEEE80211_CONF_CHANNEL_SWITCH
- if (conf->flags & IEEE80211_CONF_CHANNEL_SWITCH) {
- iwl3945_hw_channel_switch(priv, conf->channel);
- goto out;
- }
-#endif
-
- if (changed & IEEE80211_CONF_CHANGE_RADIO_ENABLED) {
- if (conf->radio_enabled &&
- iwl_radio_kill_sw_enable_radio(priv)) {
- IWL_DEBUG_MAC80211(priv, "leave - RF-KILL - "
- "waiting for uCode\n");
- goto out;
- }
-
- if (!conf->radio_enabled) {
- iwl_radio_kill_sw_disable_radio(priv);
- IWL_DEBUG_MAC80211(priv, "leave - radio disabled\n");
- goto out;
- }
- }
-
- if (iwl_is_rfkill(priv)) {
- IWL_DEBUG_MAC80211(priv, "leave - RF kill\n");
- ret = -EIO;
- goto out;
- }
-
- iwl_set_rate(priv);
-
- if (memcmp(&priv->active_rxon,
- &priv->staging_rxon, sizeof(priv->staging_rxon)))
- iwlcore_commit_rxon(priv);
- else
- IWL_DEBUG_INFO(priv, "Not re-sending same RXON configuration\n");
-
- IWL_DEBUG_MAC80211(priv, "leave\n");
-
-out:
- clear_bit(STATUS_CONF_PENDING, &priv->status);
- mutex_unlock(&priv->mutex);
- return ret;
-}
-
static void iwl3945_config_ap(struct iwl_priv *priv)
{
int rc = 0;
.stop = iwl3945_mac_stop,
.add_interface = iwl_mac_add_interface,
.remove_interface = iwl_mac_remove_interface,
- .config = iwl3945_mac_config,
+ .config = iwl_mac_config,
.config_interface = iwl3945_mac_config_interface,
.configure_filter = iwl_configure_filter,
.set_key = iwl3945_mac_set_key,