#include <common.h>
#include <net.h>
+#include <netdev.h>
#include <config.h>
+#include <fdtdec.h>
+#include <libfdt.h>
#include <malloc.h>
#include <asm/io.h>
#include <phy.h>
#include <miiphy.h>
#include <watchdog.h>
+#include <asm/system.h>
#include <asm/arch/hardware.h>
#include <asm/arch/sys_proto.h>
#define ZYNQ_GEM_NWCFG_MDCCLKDIV 0x000080000 /* Div pclk by 32, 80MHz */
#define ZYNQ_GEM_NWCFG_MDCCLKDIV2 0x0000c0000 /* Div pclk by 48, 120MHz */
-#define ZYNQ_GEM_NWCFG_INIT (ZYNQ_GEM_NWCFG_FDEN | \
+#ifdef CONFIG_ARM64
+# define ZYNQ_GEM_DBUS_WIDTH (1 << 21) /* 64 bit bus */
+#else
+# define ZYNQ_GEM_DBUS_WIDTH (0 << 21) /* 32 bit bus */
+#endif
+
+#define ZYNQ_GEM_NWCFG_INIT (ZYNQ_GEM_DBUS_WIDTH | \
+ ZYNQ_GEM_NWCFG_FDEN | \
ZYNQ_GEM_NWCFG_FSREM | \
ZYNQ_GEM_NWCFG_MDCCLKDIV)
#define ZYNQ_GEM_TXBUF_EXHAUSTED 0x08000000
#define ZYNQ_GEM_TXBUF_UNDERRUN 0x10000000
+/* Clock frequencies for different speeds */
+#define ZYNQ_GEM_FREQUENCY_10 2500000UL
+#define ZYNQ_GEM_FREQUENCY_100 25000000UL
+#define ZYNQ_GEM_FREQUENCY_1000 125000000UL
+
/* Device registers */
struct zynq_gem_regs {
u32 nwctrl; /* Network Control reg */
u32 status;
};
-#define RX_BUF 3
+#define RX_BUF 32
/* Page table entries are set to 1MB, or multiples of 1MB
* (not < 1MB). driver uses less bd's so use 1MB bdspace.
*/
static inline int mdio_wait(struct eth_device *dev)
{
struct zynq_gem_regs *regs = (struct zynq_gem_regs *)dev->iobase;
- u32 timeout = 200;
+ u32 timeout = 20000;
/* Wait till MDIO interface is ready to accept a new transaction. */
while (--timeout) {
static int zynq_gem_init(struct eth_device *dev, bd_t * bis)
{
- u32 i, rclk, clk = 0;
+ u32 i;
+ unsigned long clk_rate = 0;
struct phy_device *phydev;
const u32 stat_size = (sizeof(struct zynq_gem_regs) -
offsetof(struct zynq_gem_regs, stat)) / 4;
phy_detection(dev);
/* interface - look at tsec */
- phydev = phy_connect(priv->bus, priv->phyaddr, dev, 0);
+ phydev = phy_connect(priv->bus, priv->phyaddr, dev,
+ PHY_INTERFACE_MODE_MII);
phydev->supported = supported | ADVERTISED_Pause |
ADVERTISED_Asym_Pause;
case SPEED_1000:
writel(ZYNQ_GEM_NWCFG_INIT | ZYNQ_GEM_NWCFG_SPEED1000,
®s->nwcfg);
- rclk = (0 << 4) | (1 << 0);
- clk = (1 << 20) | (8 << 8) | (0 << 4) | (1 << 0);
+ clk_rate = ZYNQ_GEM_FREQUENCY_1000;
break;
case SPEED_100:
clrsetbits_le32(®s->nwcfg, ZYNQ_GEM_NWCFG_SPEED1000,
ZYNQ_GEM_NWCFG_INIT | ZYNQ_GEM_NWCFG_SPEED100);
- rclk = 1 << 0;
- clk = (5 << 20) | (8 << 8) | (0 << 4) | (1 << 0);
+ clk_rate = ZYNQ_GEM_FREQUENCY_100;
break;
case SPEED_10:
- rclk = 1 << 0;
- /* FIXME untested */
- clk = (5 << 20) | (8 << 8) | (0 << 4) | (1 << 0);
+ clk_rate = ZYNQ_GEM_FREQUENCY_10;
break;
}
/* Change the rclk and clk only not using EMIO interface */
if (!priv->emio)
zynq_slcr_gem_clk_setup(dev->iobase !=
- ZYNQ_GEM_BASEADDR0, rclk, clk);
+ ZYNQ_GEM_BASEADDR0, clk_rate);
setbits_le32(®s->nwctrl, ZYNQ_GEM_NWCTRL_RXEN_MASK |
ZYNQ_GEM_NWCTRL_TXEN_MASK);
priv->tx_bd->addr = (u32)ptr;
priv->tx_bd->status = (len & ZYNQ_GEM_TXBUF_FRMLEN_MASK) |
- ZYNQ_GEM_TXBUF_LAST_MASK;
+ ZYNQ_GEM_TXBUF_LAST_MASK |
+ ZYNQ_GEM_TXBUF_WRAP_MASK;
addr = (u32) ptr;
addr &= ~(ARCH_DMA_MINALIGN - 1);
size = roundup(len, ARCH_DMA_MINALIGN);
flush_dcache_range(addr, addr + size);
+
+ addr = (u32)priv->rxbuffers;
+ addr &= ~(ARCH_DMA_MINALIGN - 1);
+ size = roundup((RX_BUF * PKTSIZE_ALIGN), ARCH_DMA_MINALIGN);
+ flush_dcache_range(addr, addr + size);
barrier();
/* Start transmit */
if (frame_len) {
u32 addr = current_bd->addr & ZYNQ_GEM_RXBUF_ADD_MASK;
addr &= ~(ARCH_DMA_MINALIGN - 1);
- u32 size = roundup(frame_len, ARCH_DMA_MINALIGN);
- invalidate_dcache_range(addr, addr + size);
- NetReceive((u8 *)addr, frame_len);
+ net_process_received_packet((u8 *)addr, frame_len);
if (current_bd->status & ZYNQ_GEM_RXBUF_SOF_MASK)
priv->rx_first_buf = priv->rxbd_current;
return phywrite(dev, addr, reg, val);
}
-int zynq_gem_initialize(bd_t *bis, int base_addr, int phy_addr, u32 emio)
+int zynq_gem_initialize(bd_t *bis, phys_addr_t base_addr,
+ int phy_addr, u32 emio)
{
struct eth_device *dev;
struct zynq_gem_priv *priv;
priv->rxbuffers = memalign(ARCH_DMA_MINALIGN, RX_BUF * PKTSIZE_ALIGN);
memset(priv->rxbuffers, 0, RX_BUF * PKTSIZE_ALIGN);
- /* Align bd_space to 1MB */
+ /* Align bd_space to MMU_SECTION_SHIFT */
bd_space = memalign(1 << MMU_SECTION_SHIFT, BD_SPACE);
- mmu_set_region_dcache_behaviour((u32)bd_space, BD_SPACE, DCACHE_OFF);
+ mmu_set_region_dcache_behaviour((phys_addr_t)bd_space,
+ BD_SPACE, DCACHE_OFF);
/* Initialize the bd spaces for tx and rx bd's */
priv->tx_bd = (struct emac_bd *)bd_space;
priv->phyaddr = phy_addr;
priv->emio = emio;
- sprintf(dev->name, "Gem.%x", base_addr);
+ sprintf(dev->name, "Gem.%lx", base_addr);
dev->iobase = base_addr;
return 1;
}
+
+#ifdef CONFIG_OF_CONTROL
+int zynq_gem_of_init(const void *blob)
+{
+ int offset = 0;
+ u32 ret = 0;
+ u32 reg, phy_reg;
+
+ debug("ZYNQ GEM: Initialization\n");
+
+ do {
+ offset = fdt_node_offset_by_compatible(blob, offset,
+ "xlnx,ps7-ethernet-1.00.a");
+ if (offset != -1) {
+ reg = fdtdec_get_addr(blob, offset, "reg");
+ if (reg != FDT_ADDR_T_NONE) {
+ offset = fdtdec_lookup_phandle(blob, offset,
+ "phy-handle");
+ if (offset != -1)
+ phy_reg = fdtdec_get_addr(blob, offset,
+ "reg");
+ else
+ phy_reg = 0;
+
+ debug("ZYNQ GEM: addr %x, phyaddr %x\n",
+ reg, phy_reg);
+
+ ret |= zynq_gem_initialize(NULL, reg,
+ phy_reg, 0);
+
+ } else {
+ debug("ZYNQ GEM: Can't get base address\n");
+ return -1;
+ }
+ }
+ } while (offset != -1);
+
+ return ret;
+}
+#endif
projects / karo-tx-uboot.git / blobdiff