dm: Add support for all targets which requires MANUAL_RELOC

[karo-tx-uboot.git] / drivers / serial / serial-uclass.c

diff --git a/drivers/serial/serial-uclass.c b/drivers/serial/serial-uclass.c
index d1b5777cecda13be6191404cefe6dcf82a92f564..3fc7104359d3ccfd73e97ab81dd466cc6c62877a 100644 (file)
--- a/drivers/serial/serial-uclass.c
+++ b/drivers/serial/serial-uclass.c
@@ -258,6 +258,22 @@ static int serial_post_probe(struct udevice *dev)
 #endif
        int ret;
 
+#if defined(CONFIG_NEEDS_MANUAL_RELOC)
+       if (ops->setbrg)
+               ops->setbrg += gd->reloc_off;
+       if (ops->getc)
+               ops->getc += gd->reloc_off;
+       if (ops->putc)
+               ops->putc += gd->reloc_off;
+       if (ops->pending)
+               ops->pending += gd->reloc_off;
+       if (ops->clear)
+               ops->clear += gd->reloc_off;
+#if CONFIG_POST & CONFIG_SYS_POST_UART
+       if (ops->loop)
+               ops->loop += gd->reloc_off
+#endif
+#endif
        /* Set the baud rate */
        if (ops->setbrg) {
                ret = ops->setbrg(dev, gd->baudrate);
@@ -297,6 +313,7 @@ static int serial_pre_remove(struct udevice *dev)
 UCLASS_DRIVER(serial) = {
        .id             = UCLASS_SERIAL,
        .name           = "serial",
+       .flags          = DM_UC_FLAG_SEQ_ALIAS,
        .post_probe     = serial_post_probe,
        .pre_remove     = serial_pre_remove,
        .per_device_auto_alloc_size = sizeof(struct serial_dev_priv),