* value for this if none is specified.
* 0 - Address DMA
* 1 - Descriptor DMA (default, if available)
+ * @dma_desc_fs_enable: When DMA mode is enabled, specifies whether to use
+ * address DMA mode or descriptor DMA mode for accessing
+ * the data FIFOs in Full Speed mode only. The driver
+ * will automatically detect the value for this if none is
+ * specified.
+ * 0 - Address DMA
+ * 1 - Descriptor DMA in FS (default, if available)
* @speed: Specifies the maximum speed of operation in host and
* device mode. The actual speed depends on the speed of
* the attached device and the value of phy_type.
int otg_ver;
int dma_enable;
int dma_desc_enable;
+ int dma_desc_fs_enable;
int speed;
int enable_dynamic_fifo;
int en_multiple_tx_fifo;
* 1 - 16 bits
* 2 - 8 or 16 bits
* @snpsid: Value from SNPSID register
+ * @dev_ep_dirs: Direction of device endpoints (GHWCFG1)
*/
struct dwc2_hw_params {
unsigned op_mode:3;
unsigned arch:2;
unsigned dma_desc_enable:1;
+ unsigned dma_desc_fs_enable:1;
unsigned enable_dynamic_fifo:1;
unsigned en_multiple_tx_fifo:1;
unsigned host_rx_fifo_size:16;
unsigned host_nperio_tx_fifo_size:16;
+ unsigned dev_nperio_tx_fifo_size:16;
unsigned host_perio_tx_fifo_size:16;
unsigned nperio_tx_q_depth:3;
unsigned host_perio_tx_q_depth:3;
unsigned power_optimized:1;
unsigned utmi_phy_data_width:2;
u32 snpsid;
+ u32 dev_ep_dirs;
};
/* Size of control and EP0 buffers */
* @otg_port: OTG port number
* @frame_list: Frame list
* @frame_list_dma: Frame list DMA address
+ * @frame_list_sz: Frame list size
+ * @desc_gen_cache: Kmem cache for generic descriptors
+ * @desc_hsisoc_cache: Kmem cache for hs isochronous descriptors
*
* These are for peripheral mode:
*
u16 frame_number;
u16 periodic_qh_count;
bool bus_suspended;
+ bool new_connection;
#ifdef CONFIG_USB_DWC2_TRACK_MISSED_SOFS
#define FRAME_NUM_ARRAY_SIZE 1000
u8 otg_port;
u32 *frame_list;
dma_addr_t frame_list_dma;
+ u32 frame_list_sz;
+ struct kmem_cache *desc_gen_cache;
+ struct kmem_cache *desc_hsisoc_cache;
#ifdef DEBUG
u32 frrem_samples;
* The following functions support initialization of the core driver component
* and the DWC_otg controller
*/
+extern int dwc2_core_reset(struct dwc2_hsotg *hsotg);
+extern int dwc2_core_reset_and_force_dr_mode(struct dwc2_hsotg *hsotg);
extern void dwc2_core_host_init(struct dwc2_hsotg *hsotg);
extern int dwc2_enter_hibernation(struct dwc2_hsotg *hsotg);
extern int dwc2_exit_hibernation(struct dwc2_hsotg *hsotg, bool restore);
+void dwc2_force_dr_mode(struct dwc2_hsotg *hsotg);
+
/*
* Host core Functions.
* The following functions support managing the DWC_otg controller in host
extern void dwc2_flush_tx_fifo(struct dwc2_hsotg *hsotg, const int num);
extern void dwc2_flush_rx_fifo(struct dwc2_hsotg *hsotg);
-extern int dwc2_core_init(struct dwc2_hsotg *hsotg, bool select_phy, int irq);
+extern int dwc2_core_init(struct dwc2_hsotg *hsotg, bool initial_setup);
extern void dwc2_enable_global_interrupts(struct dwc2_hsotg *hcd);
extern void dwc2_disable_global_interrupts(struct dwc2_hsotg *hcd);
*/
extern void dwc2_set_param_dma_desc_enable(struct dwc2_hsotg *hsotg, int val);
+/*
+ * When DMA mode is enabled specifies whether to use
+ * address DMA or DMA Descritor mode with full speed devices
+ * for accessing the data FIFOs in host mode.
+ * 0 - address DMA
+ * 1 - FS DMA Descriptor(default, if available)
+ */
+extern void dwc2_set_param_dma_desc_fs_enable(struct dwc2_hsotg *hsotg,
+ int val);
+
/*
* Specifies the maximum speed of operation in host and device mode.
* The actual speed depends on the speed of the attached device and
extern int dwc2_lowlevel_hw_enable(struct dwc2_hsotg *hsotg);
extern int dwc2_lowlevel_hw_disable(struct dwc2_hsotg *hsotg);
+/*
+ * The following functions check the controller's OTG operation mode
+ * capability (GHWCFG2.OTG_MODE).
+ *
+ * These functions can be used before the internal hsotg->hw_params
+ * are read in and cached so they always read directly from the
+ * GHWCFG2 register.
+ */
+unsigned dwc2_op_mode(struct dwc2_hsotg *hsotg);
+bool dwc2_hw_is_otg(struct dwc2_hsotg *hsotg);
+bool dwc2_hw_is_host(struct dwc2_hsotg *hsotg);
+bool dwc2_hw_is_device(struct dwc2_hsotg *hsotg);
+
+/*
+ * Returns the mode of operation, host or device
+ */
+static inline int dwc2_is_host_mode(struct dwc2_hsotg *hsotg)
+{
+ return (dwc2_readl(hsotg->regs + GINTSTS) & GINTSTS_CURMODE_HOST) != 0;
+}
+static inline int dwc2_is_device_mode(struct dwc2_hsotg *hsotg)
+{
+ return (dwc2_readl(hsotg->regs + GINTSTS) & GINTSTS_CURMODE_HOST) == 0;
+}
+
/*
* Dump core registers and SPRAM
*/
#if IS_ENABLED(CONFIG_USB_DWC2_HOST) || IS_ENABLED(CONFIG_USB_DWC2_DUAL_ROLE)
extern int dwc2_hcd_get_frame_number(struct dwc2_hsotg *hsotg);
-extern void dwc2_hcd_disconnect(struct dwc2_hsotg *hsotg);
+extern void dwc2_hcd_connect(struct dwc2_hsotg *hsotg);
+extern void dwc2_hcd_disconnect(struct dwc2_hsotg *hsotg, bool force);
extern void dwc2_hcd_start(struct dwc2_hsotg *hsotg);
#else
static inline int dwc2_hcd_get_frame_number(struct dwc2_hsotg *hsotg)
{ return 0; }
-static inline void dwc2_hcd_disconnect(struct dwc2_hsotg *hsotg) {}
+static inline void dwc2_hcd_connect(struct dwc2_hsotg *hsotg) {}
+static inline void dwc2_hcd_disconnect(struct dwc2_hsotg *hsotg, bool force) {}
static inline void dwc2_hcd_start(struct dwc2_hsotg *hsotg) {}
static inline void dwc2_hcd_remove(struct dwc2_hsotg *hsotg) {}
static inline int dwc2_hcd_init(struct dwc2_hsotg *hsotg, int irq)