config USB_PHY
def_bool n
+config USB_OTG_FSM
+ tristate "USB 2.0 OTG FSM implementation"
+ depends on USB
+ select USB_OTG
+ select USB_PHY
+ help
+ Implements OTG Final State Machine as specified in On-The-Go
+ and Embedded Host Supplement to the USB Revision 2.0 Specification.
+
#
# USB Transceiver Drivers
#
in host mode, low speed.
config FSL_USB2_OTG
- tristate "Freescale USB OTG Transceiver Driver"
- depends on USB_EHCI_FSL && USB_FSL_USB2 && PM_RUNTIME
- depends on USB
+ bool "Freescale USB OTG Transceiver Driver"
+ depends on USB_EHCI_FSL && USB_FSL_USB2 && USB_OTG_FSM && PM_RUNTIME
select USB_OTG
select USB_PHY
help
Instruments OMAP processors.
This driver can also be built as a module. If so, the module
- will be called isp1301_omap.
+ will be called phy-isp1301-omap.
+
+config KEYSTONE_USB_PHY
+ tristate "Keystone USB PHY Driver"
+ depends on ARCH_KEYSTONE || COMPILE_TEST
+ select NOP_USB_XCEIV
+ help
+ Enable this to support Keystone USB phy. This driver provides
+ interface to interact with USB 2.0 and USB 3.0 PHY that is part
+ of the Keystone SOC.
config MV_U3D_PHY
bool "Marvell USB 3.0 PHY controller Driver"
optionally control of a D+ pullup GPIO as well as a VBUS
current limit regulator.
+config OMAP_OTG
+ tristate "OMAP USB OTG controller driver"
+ depends on ARCH_OMAP_OTG && EXTCON
+ help
+ Enable this to support some transceivers on OMAP1 platforms. OTG
+ controller is needed to switch between host and peripheral modes.
+
+ This driver can also be built as a module. If so, the module
+ will be called phy-omap-otg.
+
+config TAHVO_USB
+ tristate "Tahvo USB transceiver driver"
+ depends on MFD_RETU && EXTCON
+ select USB_PHY
+ help
+ Enable this to support USB transceiver on Tahvo. This is used
+ at least on Nokia 770.
+
+config TAHVO_USB_HOST_BY_DEFAULT
+ depends on TAHVO_USB
+ boolean "Device in USB host mode by default"
+ help
+ Say Y here, if you want the device to enter USB host mode
+ by default on bootup.
+
config USB_ISP1301
tristate "NXP ISP1301 USB transceiver support"
depends on USB || USB_GADGET
and OTG drivers (to be selected separately).
To compile this driver as a module, choose M here: the
- module will be called isp1301.
+ module will be called phy-isp1301.
config USB_MSM_OTG
tristate "OTG support for Qualcomm on-chip USB controller"