rename CFG_ENV macros to CONFIG_ENV

[karo-tx-uboot.git] / include / configs / PM828.h

diff --git a/include/configs/PM828.h b/include/configs/PM828.h
index 8f5be5f63a5950f6524a61a6bbf39607d58b34b6..f437d21c69b1128551d343f71e18485daf411c9f 100644 (file)
--- a/include/configs/PM828.h
+++ b/include/configs/PM828.h
@@ -43,7 +43,7 @@
 
 #define CONFIG_BOOTDELAY       5       /* autoboot after 5 seconds     */
 
-#define CONFIG_PREBOOT "echo;echo Type \"run flash_nfs\" to mount root filesystem over NFS;echo"
+#define CONFIG_PREBOOT "echo;echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;echo"
 
 #undef CONFIG_BOOTARGS
 #define CONFIG_BOOTCOMMAND                                                     \
@@ -183,7 +183,7 @@
 /*
  * Disk-On-Chip configuration
  */
-#define CFG_NAND_LEGACY
+#define CONFIG_NAND_LEGACY
 
 #define CFG_DOC_SHORT_TIMEOUT
 #define CFG_MAX_DOC_DEVICE     1       /* Max number of DOC devices    */
@@ -250,19 +250,19 @@
 
 #if 0
 /* Start port with environment in flash; switch to EEPROM later */
-#define CFG_ENV_IS_IN_FLASH    1
-#define CFG_ENV_ADDR           (CFG_FLASH_BASE+0x40000)
-#define CFG_ENV_SIZE           0x40000
-#define CFG_ENV_SECT_SIZE      0x40000
+#define CONFIG_ENV_IS_IN_FLASH 1
+#define CONFIG_ENV_ADDR                (CFG_FLASH_BASE+0x40000)
+#define CONFIG_ENV_SIZE                0x40000
+#define CONFIG_ENV_SECT_SIZE   0x40000
 #else
 /* Final version: environment in EEPROM */
-#define CFG_ENV_IS_IN_EEPROM   1
+#define CONFIG_ENV_IS_IN_EEPROM        1
 #define CFG_I2C_EEPROM_ADDR    0x58
 #define CFG_I2C_EEPROM_ADDR_LEN 1
 #define CFG_EEPROM_PAGE_WRITE_BITS     4
 #define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10      /* and takes up to 10 msec */
-#define CFG_ENV_OFFSET         512
-#define CFG_ENV_SIZE           (2048 - 512)
+#define CONFIG_ENV_OFFSET              512
+#define CONFIG_ENV_SIZE                (2048 - 512)
 #endif
 
 /*-----------------------------------------------------------------------