karo: tx53: enable 'gpio' command

[karo-tx-uboot.git] / include / configs / alpr.h

diff --git a/include/configs/alpr.h b/include/configs/alpr.h
index 2bf1986e3a7e445ec0f3b7c098bf42409fc59d3b..f113ebd74bae04c80b6b4dde00e098bc795ba530 100644 (file)
--- a/include/configs/alpr.h
+++ b/include/configs/alpr.h
@@ -14,7 +14,6 @@
 #define CONFIG_ALPR            1           /* Board is ebony           */
 #define CONFIG_440GX           1           /* Specifc GX support       */
 #define CONFIG_440             1           /* ... PPC440 family        */
-#define CONFIG_4xx             1           /* ... PPC4xx family        */
 #define CONFIG_BOARD_EARLY_INIT_F 1        /* Call board_pre_init      */
 #define CONFIG_LAST_STAGE_INIT 1           /* call last_stage_init()   */
 
@@ -218,18 +217,12 @@
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_DHCP
 #define CONFIG_CMD_EEPROM
-#define CONFIG_CMD_FPGA
+#define CONFIG_CMD_FPGA_LOADMK
 #define CONFIG_CMD_I2C
-#undef CONFIG_CMD_LOADB
-#undef CONFIG_CMD_LOADS
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_NAND
-#define CONFIG_CMD_NET
-#undef CONFIG_CMD_NFS
 #define CONFIG_CMD_PCI
 
 #undef CONFIG_WATCHDOG                 /* watchdog disabled            */
@@ -324,6 +317,8 @@
 #define CONFIG_SYS_NAND_BASE_LIST      { CONFIG_SYS_NAND_BASE + 0, CONFIG_SYS_NAND_BASE + 2,   \
                                  CONFIG_SYS_NAND_BASE + 4, CONFIG_SYS_NAND_BASE + 6 }
 #define CONFIG_SYS_NAND_QUIET_TEST     1       /* don't warn upon unknown NAND flash   */
+#define CONFIG_SYS_NAND_MAX_OOBFREE    2
+#define CONFIG_SYS_NAND_MAX_ECCPOS     56
 
 /*-----------------------------------------------------------------------
  * External Bus Controller (EBC) Setup
@@ -347,7 +342,6 @@
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
-#define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use */
 #endif
 
 /* pass open firmware flat tree */