#error No card type defined!
#endif
-/*
- * Define processor
- * possible values for Urmel board: only Coldfire M5373 processor supported
- * (please do not change)
- */
-
-/* it seems not clear yet which processor defines we should use */
-#define CONFIG_MCF537x /* define processor family */
-#define CONFIG_MCF532x /* define processor family */
-#define CONFIG_M5373 /* define processor type */
#define CONFIG_ASTRO5373L /* define board type */
/* Command line configuration */
-#include <config_cmd_default.h>
-
/*
* CONFIG_RAM defines if u-boot is loaded via BDM (or started from
* a different bootloader that has already performed RAM setup) or
#define CONFIG_CMD_CACHE
#define CONFIG_CMD_DATE
#define CONFIG_CMD_ELF
-#define CONFIG_CMD_FLASH
#define CONFIG_CMD_I2C
-#define CONFIG_CMD_MEMORY
-#define CONFIG_CMD_MISC
-#define CONFIG_CMD_XIMG
-#undef CONFIG_CMD_NET
-#undef CONFIG_CMD_NFS
#if ENABLE_JFFS
#define CONFIG_CMD_JFFS2
#endif
#define CONFIG_CMD_REGINFO
-#define CONFIG_CMD_LOADS
-#define CONFIG_CMD_LOADB
-#define CONFIG_CMD_FPGA
#define CONFIG_CMD_FPGA_LOADMK
#define CONFIG_CMDLINE_EDITING
#define CONFIG_BOOTARGS " console=ttyS2,115200 rootfstype=romfs"\
" loaderversion=$loaderversion"
-#define CONFIG_SYS_PROMPT "URMEL > "
-
/* default RAM address for user programs */
#define CONFIG_SYS_LOAD_ADDR 0x20000
#define CONFIG_SYS_FLASH_USE_BUFFER_WRITE 1
#define CONFIG_SYS_FLASH_CFI_NONBLOCK 1
+#define LDS_BOARD_TEXT \
+ . = DEFINED(env_offset) ? env_offset : .; \
+ common/env_embedded.o (.text*)
+
#if ENABLE_JFFS
/* JFFS Partition offset set */
#define CONFIG_SYS_JFFS2_FIRST_BANK 0