karo: tx28: enable 'gpio' command

[karo-tx-uboot.git] / include / configs / cmi_mpc5xx.h

diff --git a/include/configs/cmi_mpc5xx.h b/include/configs/cmi_mpc5xx.h
index 417c8735741f3c4e5075f24699dae96b488df1f2..d081865749cb4fa0901338aa49aa611e4d08eda3 100644 (file)
--- a/include/configs/cmi_mpc5xx.h
+++ b/include/configs/cmi_mpc5xx.h
@@ -44,22 +44,8 @@
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
-#undef CONFIG_CMD_NET          /* disabeled - causes compile errors */
-#undef CONFIG_CMD_NFS
-
-#define CONFIG_CMD_MEMORY
-#define CONFIG_CMD_LOADB
 #define CONFIG_CMD_REGINFO
-#define CONFIG_CMD_FLASH
-#define CONFIG_CMD_LOADS
 #define CONFIG_CMD_ASKENV
-#define CONFIG_CMD_BDI
-#define CONFIG_CMD_CONSOLE
-#define CONFIG_CMD_SAVEENV
-#define CONFIG_CMD_RUN
-#define CONFIG_CMD_IMI
 
 
 #if 0
@@ -82,7 +68,6 @@
  */
 
 #define        CONFIG_SYS_LONGHELP                             /* undef to save memory         */
-#define        CONFIG_SYS_PROMPT               "=> "           /* Monitor Command Prompt       */
 #if defined(CONFIG_CMD_KGDB)
 #define        CONFIG_SYS_CBSIZE               1024            /* Console I/O Buffer Size      */
 #else
@@ -97,8 +82,6 @@
 
 #define        CONFIG_SYS_LOAD_ADDR            0x100000        /* default load address         */
 
-#define        CONFIG_SYS_HZ                   1000            /* Decrementer freq: 1 ms ticks */
-
 #define CONFIG_SYS_BAUDRATE_TABLE      { 9600, 19200, 38400, 57600, 115200, 1250000 }