karo: tx6: increase SYS_BOOTM_LEN to 32MiB

[karo-tx-uboot.git] / include / configs / db-mv784mp-gp.h

diff --git a/include/configs/db-mv784mp-gp.h b/include/configs/db-mv784mp-gp.h
index 3911b428be1eea3cff0d478cf6d51d87c163e6e5..f612e72d885858943cc521119f189be31d6b0a2e 100644 (file)
--- a/include/configs/db-mv784mp-gp.h
+++ b/include/configs/db-mv784mp-gp.h
@@ -17,7 +17,12 @@
 #define CONFIG_SYS_GENERIC_BOARD
 #define CONFIG_DISPLAY_BOARDINFO_LATE
 
-#define        CONFIG_SYS_TEXT_BASE    0x04000000
+/*
+ * TEXT_BASE needs to be below 16MiB, since this area is scrubbed
+ * for DDR ECC byte filling in the SPL before loading the main
+ * U-Boot into it.
+ */
+#define        CONFIG_SYS_TEXT_BASE    0x00800000
 #define CONFIG_SYS_TCLK                250000000       /* 250MHz */
 
 /*
@@ -28,6 +33,8 @@
 #define CONFIG_CMD_ENV
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_IDE
+#define CONFIG_CMD_NAND
+#define CONFIG_CMD_PCI
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_SF
 #define CONFIG_CMD_SPI
@@ -47,6 +54,7 @@
 #define CONFIG_USB_STORAGE
 #define CONFIG_USB_EHCI_MARVELL
 #define CONFIG_EHCI_IS_TDI
+#define CONFIG_USB_MAX_CONTROLLER_COUNT 3
 
 /* SPI NOR flash default params, used by sf commands */
 #define CONFIG_SF_DEFAULT_SPEED                1000000
@@ -96,6 +104,17 @@
 #define CONFIG_DOS_PARTITION
 #endif /* CONFIG_CMD_IDE */
 
+/* PCIe support */
+#define CONFIG_PCI
+#define CONFIG_PCI_MVEBU
+#define CONFIG_PCI_PNP
+#define CONFIG_PCI_SCAN_SHOW
+#define CONFIG_E1000   /* enable Intel E1000 support for testing */
+
+/* NAND */
+#define CONFIG_SYS_NAND_USE_FLASH_BBT
+#define CONFIG_SYS_NAND_ONFI_DETECTION
+
 /*
  * mv-common.h should be defined after CMD configs since it used them
  * to enable certain macros