karo: tx28: enable 'gpio' command

[karo-tx-uboot.git] / include / configs / pxa255_idp.h

diff --git a/include/configs/pxa255_idp.h b/include/configs/pxa255_idp.h
index 5ea7e67da5f11a0b14a86f6cb94ee74a9e5795b4..332d79f89f535d10454a0e45a7e17e1a699bffda 100644 (file)
--- a/include/configs/pxa255_idp.h
+++ b/include/configs/pxa255_idp.h
@@ -104,8 +104,6 @@
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_FAT
 #define CONFIG_CMD_DHCP
 
@@ -199,7 +197,6 @@
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   115200          /* speed to run kgdb serial port */
-#define CONFIG_KGDB_SER_INDEX  2               /* which serial port to use */
 #endif
 
 /*
@@ -208,10 +205,10 @@
 #define CONFIG_SYS_HUSH_PARSER         1
 
 #define CONFIG_SYS_LONGHELP                            /* undef to save memory         */
+#undef CONFIG_SYS_PROMPT
 #ifdef CONFIG_SYS_HUSH_PARSER
 #define CONFIG_SYS_PROMPT              "$ "            /* Monitor Command Prompt */
 #else
-#define CONFIG_SYS_PROMPT              "=> "           /* Monitor Command Prompt */
 #endif
 #define CONFIG_SYS_CBSIZE              256             /* Console I/O Buffer Size      */
 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
@@ -224,7 +221,6 @@
 
 #define CONFIG_SYS_LOAD_ADDR           0xa0800000      /* default load address */
 
-#define CONFIG_SYS_HZ                  1000
 #define CONFIG_SYS_CPUSPEED            0x161           /* set core clock to 400/200/100 MHz */
 
 #define RTC    1                               /* enable 32KHz osc */