karo: tx28: enable 'gpio' command

[karo-tx-uboot.git] / include / configs / socfpga_arria5.h

diff --git a/include/configs/socfpga_arria5.h b/include/configs/socfpga_arria5.h
index 2d31df8a4547d6c18d223a1f3690a83ee80e440d..3193684798c809137658d903482a85d1a6f2abe5 100644 (file)
--- a/include/configs/socfpga_arria5.h
+++ b/include/configs/socfpga_arria5.h
@@ -23,6 +23,7 @@
 #define CONFIG_CMD_EXT4_WRITE
 #define CONFIG_CMD_FAT
 #define CONFIG_CMD_FS_GENERIC
+#define CONFIG_CMD_GPIO
 #define CONFIG_CMD_GREPENV
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_MMC
@@ -30,7 +31,6 @@
 #define CONFIG_CMD_USB
 #define CONFIG_CMD_USB_MASS_STORAGE
 
-
 /* Memory configurations */
 #define PHYS_SDRAM_1_SIZE              0x40000000      /* 1GiB on SoCDK */
 
@@ -43,13 +43,11 @@
 #else
 #define CONFIG_BOOTCOMMAND     "run mmcload; run mmcboot"
 #endif
-#define CONFIG_LOADADDR                0x8000
+#define CONFIG_LOADADDR                0x01000000
 #define CONFIG_SYS_LOAD_ADDR   CONFIG_LOADADDR
 
 /* Ethernet on SoC (EMAC) */
 #if defined(CONFIG_CMD_NET)
-#define CONFIG_EMAC_BASE               SOCFPGA_EMAC1_ADDRESS
-#define CONFIG_PHY_INTERFACE_MODE      PHY_INTERFACE_MODE_RGMII
 
 /* PHY */
 #define CONFIG_PHY_MICREL