arm: spear: Some changes / updates to the x600 config header

[karo-tx-uboot.git] / include / configs / socfpga_cyclone5.h

diff --git a/include/configs/socfpga_cyclone5.h b/include/configs/socfpga_cyclone5.h
index 80d3f281f4da2562881268eb3c057008aaacb7a0..db38de7fe2931a39d795b47507a5a5161a6f462e 100644 (file)
--- a/include/configs/socfpga_cyclone5.h
+++ b/include/configs/socfpga_cyclone5.h
@@ -5,9 +5,6 @@
  */
 
 #include <asm/arch/socfpga_base_addrs.h>
-#include "../../board/altera/socfpga/qts/pinmux_config.h"
-#include "../../board/altera/socfpga/qts/iocsr_config.h"
-#include "../../board/altera/socfpga/qts/pll_config.h"
 
 /* U-Boot Commands */
 #define CONFIG_SYS_NO_FLASH
@@ -24,6 +21,7 @@
 #define CONFIG_CMD_EXT4_WRITE
 #define CONFIG_CMD_FAT
 #define CONFIG_CMD_FS_GENERIC
+#define CONFIG_CMD_GPIO
 #define CONFIG_CMD_GREPENV
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_MMC
@@ -31,7 +29,6 @@
 #define CONFIG_CMD_USB
 #define CONFIG_CMD_USB_MASS_STORAGE
 
-
 /* Memory configurations */
 #define PHYS_SDRAM_1_SIZE              0x40000000      /* 1GiB on SoCDK */
 
@@ -43,13 +40,11 @@
 #else
 #define CONFIG_BOOTCOMMAND     "run mmcload; run mmcboot"
 #endif
-#define CONFIG_LOADADDR                0x8000
+#define CONFIG_LOADADDR                0x01000000
 #define CONFIG_SYS_LOAD_ADDR   CONFIG_LOADADDR
 
 /* Ethernet on SoC (EMAC) */
 #if defined(CONFIG_CMD_NET)
-#define CONFIG_EMAC_BASE               SOCFPGA_EMAC1_ADDRESS
-#define CONFIG_PHY_INTERFACE_MODE      PHY_INTERFACE_MODE_RGMII
 
 /* PHY */
 #define CONFIG_PHY_MICREL