* Common configurations used for both spear3xx as well as spear6xx
*/
+#define CONFIG_SYS_GENERIC_BOARD
+
/* U-boot Load Address */
#define CONFIG_SYS_TEXT_BASE 0x00700000
/* Ethernet driver configuration */
#define CONFIG_MII
-#define CONFIG_DESIGNWARE_ETH
-#define CONFIG_NET_MULTI
#define CONFIG_PHYLIB
#define CONFIG_PHY_RESET_DELAY 10000 /* in usec */
#define CONFIG_PHY_GIGE /* Include GbE speed/duplex detection */
#define CONFIG_EXTRA_ENV_USBTTY "usbtty=cdc_acm\0"
/* I2C driver configuration */
-#define CONFIG_HARD_I2C
-#define CONFIG_DW_I2C
+#define CONFIG_SYS_I2C
+#define CONFIG_SYS_I2C_DW
#if defined(CONFIG_SPEAR600)
#define CONFIG_SYS_I2C_BASE 0xD0200000
#elif defined(CONFIG_SPEAR300)
#define CONFIG_CMD_I2C
#define CONFIG_CMD_NAND
#define CONFIG_CMD_ENV
-#define CONFIG_CMD_MEMORY
-#define CONFIG_CMD_RUN
#define CONFIG_CMD_SAVES
-#define CONFIG_CMD_NET
#define CONFIG_CMD_MII
#define CONFIG_CMD_PING
#define CONFIG_CMD_DHCP
-/* This must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <config_cmd_default.h>
-
/*
* Default Environment Varible definitions
*/
#define CONFIG_SETUP_MEMORY_TAGS
#define CONFIG_MISC_INIT_R
#define CONFIG_ZERO_BOOTDELAY_CHECK
-#define CONFIG_AUTOBOOT_KEYED
-#define CONFIG_AUTOBOOT_STOP_STR " "
-#define CONFIG_AUTOBOOT_PROMPT \
- "Hit SPACE in %d seconds to stop autoboot.\n", bootdelay
#define CONFIG_SYS_MEMTEST_START 0x00800000
#define CONFIG_SYS_MEMTEST_END 0x04000000
#define CONFIG_SYS_MALLOC_LEN (1024*1024)
#define CONFIG_IDENT_STRING "-SPEAr"
#define CONFIG_SYS_LONGHELP
-#define CONFIG_SYS_PROMPT "u-boot> "
#define CONFIG_CMDLINE_EDITING
#define CONFIG_SYS_CBSIZE 256
#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \