/*--------------------------------------------------------------------------*/
-#define CONFIG_ARM926EJS /* This is an ARM926EJS Core */
-#define CONFIG_AT91FAMILY
#define CONFIG_AT91SAM9263 /* It's an Atmel AT91SAM9263 SoC*/
#define CONFIG_VL_MA2SC /* on an VL_MA2SC Board */
#define CONFIG_ARCH_CPU_INIT
/*
* Command line configuration.
*/
-#include <config_cmd_default.h>
-#undef CONFIG_CMD_BDI
-#undef CONFIG_CMD_FPGA
-#undef CONFIG_CMD_IMI
-#undef CONFIG_CMD_LOADS
-
#define CONFIG_CMD_BMP
#define CONFIG_CMD_DATE
#define CONFIG_CMD_DHCP
/* USB */
#define CONFIG_USB_ATMEL
+#define CONFIG_USB_ATMEL_CLK_SEL_PLLB
#define CONFIG_USB_OHCI_NEW
#define CONFIG_DOS_PARTITION
#define CONFIG_SYS_USB_OHCI_CPU_INIT
/* clocks */
-#define CONFIG_SYS_HZ 1000
#define CONFIG_SYS_AT91_SLOW_CLOCK 32768 /* slow clock */
#define MHZ180
#define CONFIG_SYS_NAND_DBW_8 1
#define CONFIG_SYS_NAND_MASK_ALE (1 << 21) /* our ALE is AD21 */
#define CONFIG_SYS_NAND_MASK_CLE (1 << 22) /* our CLE is AD22 */
-#define CONFIG_SYS_NAND_ENABLE_PIN AT91_PIO_PORTD, 15
-#define CONFIG_SYS_NAND_READY_PIN AT91_PIO_PORTB, 0
-#define CONFIG_SYS_64BIT_VSPRINTF /* needed for nand_util.c */
+#define CONFIG_SYS_NAND_ENABLE_PIN GPIO_PIN_PD(15)
+#define CONFIG_SYS_NAND_READY_PIN GPIO_PIN_PB(0)
#endif
/* Ethernet */
#define CONFIG_MACB
#define CONFIG_RMII
-#define CONFIG_NET_MULTI
#define CONFIG_NET_RETRY_COUNT 5
+#define CONFIG_AT91_WANTS_COMMON_PHY
#define CONFIG_OVERWRITE_ETHADDR_ONCE
#define CONFIG_SYS_BAUDRATE_TABLE {312500, 230400, 115200, 19200, \
38400, 57600, 9600 }
-#define CONFIG_SYS_PROMPT "U-Boot> "
#define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */
#define CONFIG_SYS_MAXARGS 32 /* max number of command args */
#define CONFIG_SYS_PBSIZE \
*/
#define CONFIG_SYS_MALLOC_LEN \
ROUND(3 * CONFIG_ENV_SIZE + 128 * 1024, 0x1000)
-#define CONFIG_SYS_GBL_DATA_SIZE 128 /* 128 bytes for initial data */
#ifndef CONFIG_RAMLOAD
#define CONFIG_BOOTCOMMAND "run nfsboot"