* @param state new state of the LDO/FET : EC_LDO_STATE_ON|OFF
* @return 0 if ok, -1 on error
*/
-int cros_ec_set_ldo(struct cros_ec_dev *dev, uint8_t index, uint8_t state);
+int cros_ec_set_ldo(struct udevice *dev, uint8_t index, uint8_t state);
/**
* Read back a LDO / FET current state.
* @param state current state of the LDO/FET : EC_LDO_STATE_ON|OFF
* @return 0 if ok, -1 on error
*/
-int cros_ec_get_ldo(struct cros_ec_dev *dev, uint8_t index, uint8_t *state);
+int cros_ec_get_ldo(struct udevice *dev, uint8_t index, uint8_t *state);
/**
* Get access to the error reported when cros_ec_board_init() was called
*/
int cros_ec_i2c_tunnel(struct udevice *dev, struct i2c_msg *msg, int nmsgs);
-/*
- * Tunnel an I2C transfer to the EC
- *
- * @param dev CROS-EC device
- * @param chip Chip address (7-bit I2C address)
- * @param addr Register address to read/write
- * @param alen Length of register address in bytes
- * @param buffer Buffer containing data to read/write
- * @param len Length of buffer
- * @param is_read 1 if this is a read, 0 if this is a write
- */
-int cros_ec_i2c_xfer_old(struct cros_ec_dev *dev, uchar chip, uint addr,
- int alen, uchar *buffer, int len, int is_read);
-
#endif