union i2c_smbus_data;
struct i2c_board_info;
+#if defined(CONFIG_I2C) || defined(CONFIG_I2C_MODULE)
/*
* The master routines are the ones normally used to transmit data to devices
* on a bus (or read from them). Apart from two basic transfer functions to
extern s32 i2c_smbus_write_i2c_block_data(struct i2c_client *client,
u8 command, u8 length,
const u8 *values);
+#endif /* I2C */
/**
* struct i2c_driver - represent an I2C device driver
* @driver: device's driver, hence pointer to access routines
* @dev: Driver model device node for the slave.
* @irq: indicates the IRQ generated by this device (if any)
- * @detected: member of an i2c_driver.clients list
+ * @detected: member of an i2c_driver.clients list or i2c-core's
+ * userspace_devices list
*
* An i2c_client identifies a single device (i.e. chip) connected to an
* i2c bus. The behaviour exposed to Linux is defined by the driver
.type = dev_type, .addr = (dev_addr)
+#if defined(CONFIG_I2C) || defined(CONFIG_I2C_MODULE)
/* Add-on boards should register/unregister their devices; e.g. a board
* with integrated I2C, a config eeprom, sensors, and a codec that's
* used in conjunction with the primary hardware.
i2c_new_dummy(struct i2c_adapter *adap, u16 address);
extern void i2c_unregister_device(struct i2c_client *);
+#endif /* I2C */
/* Mainboard arch_initcall() code should register all its I2C devices.
* This is done at arch_initcall time, before declaring any i2c adapters.
{
return 0;
}
-#endif
+#endif /* I2C_BOARDINFO */
/*
* The following structs are for those who like to implement new bus drivers:
/* The numbers to use to set I2C bus address */
#define ANY_I2C_BUS 0xffff
+/* Construct an I2C_CLIENT_END-terminated array of i2c addresses */
+#define I2C_ADDRS(addr, addrs...) \
+ ((const unsigned short []){ addr, ## addrs, I2C_CLIENT_END })
+
/* ----- functions exported by i2c.o */
/* administration...
*/
+#if defined(CONFIG_I2C) || defined(CONFIG_I2C_MODULE)
extern int i2c_add_adapter(struct i2c_adapter *);
extern int i2c_del_adapter(struct i2c_adapter *);
extern int i2c_add_numbered_adapter(struct i2c_adapter *);
{
return adap->nr;
}
+#endif /* I2C */
#endif /* __KERNEL__ */
/**