ATA_DFLAG_LBA48 = (1 << 1), /* device supports LBA48 */
ATA_DFLAG_CDB_INTR = (1 << 2), /* device asserts INTRQ when ready for CDB */
ATA_DFLAG_NCQ = (1 << 3), /* device supports NCQ */
+ ATA_DFLAG_FLUSH_EXT = (1 << 4), /* do FLUSH_EXT instead of FLUSH */
ATA_DFLAG_CFG_MASK = (1 << 8) - 1,
ATA_DFLAG_PIO = (1 << 8), /* device limited to PIO mode */
- ATA_DFLAG_NCQ_OFF = (1 << 9), /* devied limited to non-NCQ mode */
+ ATA_DFLAG_NCQ_OFF = (1 << 9), /* device limited to non-NCQ mode */
ATA_DFLAG_SUSPENDED = (1 << 10), /* device suspended */
ATA_DFLAG_INIT_MASK = (1 << 16) - 1,
ATA_FLAG_SKIP_D2H_BSY = (1 << 12), /* can't wait for the first D2H
* Register FIS clearing BSY */
ATA_FLAG_DEBUGMSG = (1 << 13),
+ ATA_FLAG_SETXFER_POLLING= (1 << 14), /* use polling for SETXFER */
/* The following flag belongs to ap->pflags but is kept in
* ap->flags because it's referenced in many LLDs and will be
ATA_EHI_QUIET = (1 << 3), /* be quiet */
ATA_EHI_DID_RESET = (1 << 16), /* already reset this port */
+ ATA_EHI_PRINTINFO = (1 << 17), /* print configuration info */
+ ATA_EHI_SETMODE = (1 << 18), /* configure transfer mode */
+ ATA_EHI_POST_SETMODE = (1 << 19), /* revaildating after setmode */
ATA_EHI_RESET_MODIFIER_MASK = ATA_EHI_RESUME_LINK,
(some horkage may be drive/controller pair dependant */
ATA_HORKAGE_DIAGNOSTIC = (1 << 0), /* Failed boot diag */
+ ATA_HORKAGE_NODMA = (1 << 1), /* DMA problems */
+ ATA_HORKAGE_NONCQ = (1 << 2), /* Don't use NCQ */
};
enum hsm_task_states {
- HSM_ST_UNKNOWN, /* state unknown */
HSM_ST_IDLE, /* no command on going */
HSM_ST, /* (waiting the device to) transfer data */
HSM_ST_LAST, /* (waiting the device to) complete command */
AC_ERR_SYSTEM = (1 << 6), /* system error */
AC_ERR_INVALID = (1 << 7), /* invalid argument */
AC_ERR_OTHER = (1 << 8), /* unknown */
+ AC_ERR_NODEV_HINT = (1 << 9), /* polling device detection hint */
};
/* forward declarations */
struct ata_host *host;
struct device *dev;
- struct work_struct port_task;
- struct work_struct hotplug_task;
+ void *port_task_data;
+ struct delayed_work port_task;
+ struct delayed_work hotplug_task;
struct work_struct scsi_rescan_task;
unsigned int hsm_task_state;
extern int sata_phy_resume(struct ata_port *ap, const unsigned long *param);
extern int ata_std_prereset(struct ata_port *ap);
extern int ata_std_softreset(struct ata_port *ap, unsigned int *classes);
+extern int sata_port_hardreset(struct ata_port *ap,
+ const unsigned long *timing);
extern int sata_std_hardreset(struct ata_port *ap, unsigned int *class);
extern void ata_std_postreset(struct ata_port *ap, unsigned int *classes);
-extern int ata_dev_revalidate(struct ata_device *dev, int post_reset);
extern void ata_port_disable(struct ata_port *);
extern void ata_std_ports(struct ata_ioports *ioaddr);
#ifdef CONFIG_PCI
extern int ata_host_suspend(struct ata_host *host, pm_message_t mesg);
extern void ata_host_resume(struct ata_host *host);
extern int ata_ratelimit(void);
-extern unsigned int ata_busy_sleep(struct ata_port *ap,
- unsigned long timeout_pat,
- unsigned long timeout);
-extern void ata_port_queue_task(struct ata_port *ap, void (*fn)(void *),
+extern int ata_busy_sleep(struct ata_port *ap,
+ unsigned long timeout_pat, unsigned long timeout);
+extern void ata_port_queue_task(struct ata_port *ap, work_func_t fn,
void *data, unsigned long delay);
extern u32 ata_wait_register(void __iomem *reg, u32 mask, u32 val,
unsigned long interval_msec,
unsigned int ofs, unsigned int len);
extern void ata_id_c_string(const u16 *id, unsigned char *s,
unsigned int ofs, unsigned int len);
+extern unsigned long ata_device_blacklisted(const struct ata_device *dev);
extern void ata_bmdma_setup (struct ata_queued_cmd *qc);
extern void ata_bmdma_start (struct ata_queued_cmd *qc);
extern void ata_bmdma_stop(struct ata_queued_cmd *qc);
udelay(10);
status = ata_chk_status(ap);
max--;
- } while ((status & bits) && (max > 0));
+ } while (status != 0xff && (status & bits) && (max > 0));
return status;
}
{
u8 status = ata_busy_wait(ap, ATA_BUSY | ATA_DRQ, 1000);
- if (status & (ATA_BUSY | ATA_DRQ)) {
+ if (status != 0xff && (status & (ATA_BUSY | ATA_DRQ))) {
unsigned long l = ap->ioaddr.status_addr;
if (ata_msg_warn(ap))
printk(KERN_WARNING "ATA: abnormal status 0x%X on port 0x%lX\n",
static inline void ata_qc_reinit(struct ata_queued_cmd *qc)
{
+ qc->dma_dir = DMA_NONE;
qc->__sg = NULL;
qc->flags = 0;
qc->cursect = qc->cursg = qc->cursg_ofs = 0;
qc->nsect = 0;
qc->nbytes = qc->curbytes = 0;
+ qc->n_elem = 0;
qc->err_mask = 0;
+ qc->pad_len = 0;
ata_tf_init(qc->dev, &qc->tf);
qc->result_tf.feature = 0;
}
-/**
- * ata_irq_on - Enable interrupts on a port.
- * @ap: Port on which interrupts are enabled.
- *
- * Enable interrupts on a legacy IDE device using MMIO or PIO,
- * wait for idle, clear any pending interrupts.
- *
- * LOCKING:
- * Inherited from caller.
- */
-
-static inline u8 ata_irq_on(struct ata_port *ap)
-{
- struct ata_ioports *ioaddr = &ap->ioaddr;
- u8 tmp;
-
- ap->ctl &= ~ATA_NIEN;
- ap->last_ctl = ap->ctl;
-
- if (ap->flags & ATA_FLAG_MMIO)
- writeb(ap->ctl, (void __iomem *) ioaddr->ctl_addr);
- else
- outb(ap->ctl, ioaddr->ctl_addr);
- tmp = ata_wait_idle(ap);
-
- ap->ops->irq_clear(ap);
-
- return tmp;
-}
-
-
/**
* ata_irq_ack - Acknowledge a device interrupt.
* @ap: Port on which interrupts are enabled.