Add NAND partition table, EK board support boot up NAND flash using
the same NAND partition table
Add Index in this file
Signed-off-by: Bo Shen <voice.shen@atmel.com>
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>
Atmel AT91 Evaluation kits
Atmel AT91 Evaluation kits
+Index
+ - I. Board mapping & boot media
+ - II. NAND partition table
+ - III. watchdog support
+
I. Board mapping & boot media
------------------------------------------------------------------------------
AT91SAM9260EK, AT91SAM9G20EK & AT91SAM9XEEK
I. Board mapping & boot media
------------------------------------------------------------------------------
AT91SAM9260EK, AT91SAM9G20EK & AT91SAM9XEEK
make sama5d3xek_serialflash_config - use serial flash
make sama5d3xek_serialflash_config - use serial flash
+II. NAND partition table
+
+ All the board support boot from NAND flash will use the following NAND
+ partition table
+
+ 0x00000000 - 0x0003FFFF bootstrap (256 KiB)
+ 0x00040000 - 0x000BFFFF u-boot (512 KiB)
+ 0x000C0000 - 0x000FFFFF env (256 KiB)
+ 0x00100000 - 0x0013FFFF env_redundant (256 KiB)
+ 0x00140000 - 0x0017FFFF spare (256 KiB)
+ 0x00180000 - 0x001FFFFF dtb (512 KiB)
+ 0x00200000 - 0x007FFFFF kernel (6 MiB)
+ 0x00800000 - 0xxxxxxxxx rootfs (All left)
+
+III. Watchdog support
For security reasons, the at91 watchdog is running at boot time and,
if deactivated, cannot be used anymore.
For security reasons, the at91 watchdog is running at boot time and,
if deactivated, cannot be used anymore.