HT/VHT MCS rateset should be filled only for configured chainmask
rather that max supported chainmask. Fix that by checking configured
chainmask while filling HT/VHT MCS rate map.
Signed-off-by: Rajkumar Manoharan <rmanohar@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
mcs_map = 0;
for (i = 0; i < 8; i++) {
mcs_map = 0;
for (i = 0; i < 8; i++) {
- if (i < ar->num_rf_chains)
+ if ((i < ar->num_rf_chains) && (ar->cfg_tx_chainmask & BIT(i)))
mcs_map |= IEEE80211_VHT_MCS_SUPPORT_0_9 << (i*2);
else
mcs_map |= IEEE80211_VHT_MCS_NOT_SUPPORTED << (i*2);
mcs_map |= IEEE80211_VHT_MCS_SUPPORT_0_9 << (i*2);
else
mcs_map |= IEEE80211_VHT_MCS_NOT_SUPPORTED << (i*2);
if (ar->vht_cap_info & WMI_VHT_CAP_MAX_MPDU_LEN_MASK)
ht_cap.cap |= IEEE80211_HT_CAP_MAX_AMSDU;
if (ar->vht_cap_info & WMI_VHT_CAP_MAX_MPDU_LEN_MASK)
ht_cap.cap |= IEEE80211_HT_CAP_MAX_AMSDU;
- for (i = 0; i < ar->num_rf_chains; i++)
- ht_cap.mcs.rx_mask[i] = 0xFF;
+ for (i = 0; i < ar->num_rf_chains; i++) {
+ if (ar->cfg_rx_chainmask & BIT(i))
+ ht_cap.mcs.rx_mask[i] = 0xFF;
+ }
ht_cap.mcs.tx_params |= IEEE80211_HT_MCS_TX_DEFINED;
ht_cap.mcs.tx_params |= IEEE80211_HT_MCS_TX_DEFINED;