hwmon: (ads7871) Fix multi-line comments

Cc: Paul Thomas <pthomas8589@gmail.com>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>

diff --git a/drivers/hwmon/ads7871.c b/drivers/hwmon/ads7871.c
index 11a5f5f69071b6f4706dc807f9f999bb2dec9f58..e65c6e45d36b05a24241680558fd2012be3f3c85 100644 (file)
--- a/drivers/hwmon/ads7871.c
+++ b/drivers/hwmon/ads7871.c
@@ -34,9 +34,11 @@
 #define REG_SER_CONTROL 24 /*Serial Interface Control Register*/
 #define REG_ID         31 /*ID Register*/
 
-/*From figure 17 in the datasheet
-* These bits get ORed with the address to form
-* the instruction byte */
+/*
+ * From figure 17 in the datasheet
+ * These bits get ORed with the address to form
+ * the instruction byte
+ */
 /*Instruction Bit masks*/
 #define INST_MODE_bm   (1<<7)
 #define INST_READ_bm   (1<<6)
@@ -105,8 +107,10 @@ static ssize_t show_voltage(struct device *dev,
        uint8_t channel, mux_cnv;
 
        channel = attr->index;
-       /*TODO: add support for conversions
-        *other than single ended with a gain of 1*/
+       /*
+        * TODO: add support for conversions
+        * other than single ended with a gain of 1
+        */
        /*MUX_M3_bm forces single ended*/
        /*This is also where the gain of the PGA would be set*/
        ads7871_write_reg8(spi, REG_GAIN_MUX,
@@ -114,8 +118,10 @@ static ssize_t show_voltage(struct device *dev,
 
        ret = ads7871_read_reg8(spi, REG_GAIN_MUX);
        mux_cnv = ((ret & MUX_CNV_bm)>>MUX_CNV_bv);
-       /*on 400MHz arm9 platform the conversion
-        *is already done when we do this test*/
+       /*
+        * on 400MHz arm9 platform the conversion
+        * is already done when we do this test
+        */
        while ((i < 2) && mux_cnv) {
                i++;
                ret = ads7871_read_reg8(spi, REG_GAIN_MUX);
@@ -179,8 +185,10 @@ static int __devinit ads7871_probe(struct spi_device *spi)
        ret = ads7871_read_reg8(spi, REG_OSC_CONTROL);
 
        dev_dbg(&spi->dev, "REG_OSC_CONTROL write:%x, read:%x\n", val, ret);
-       /*because there is no other error checking on an SPI bus
-       we need to make sure we really have a chip*/
+       /*
+        * because there is no other error checking on an SPI bus
+        * we need to make sure we really have a chip
+        */
        if (val != ret) {
                err = -ENODEV;
                goto exit;