If we make all QSPI (SPI protocol) addressing consistent across all ColdFire
family members then we will be able to remove the duplicated plaform data
and code and use a single setup for all.
So modify the ColdFire 5249 QSPI addressing so that:
. base addresses are absolute (not relative to MBAR peripheral register)
. use a common name for IRQs used
. move chip select definitions (CS) to appropriate header
Signed-off-by: Greg Ungerer <gerg@uclinux.org>
#define MCFUART_BASE0 (MCF_MBAR + 0x1c0) /* Base address UART0 */
#define MCFUART_BASE1 (MCF_MBAR + 0x200) /* Base address UART1 */
+/*
+ * QSPI module.
+ */
+#define MCFQSPI_BASE (MCF_MBAR + 0x300) /* Base address QSPI */
+#define MCFQSPI_SIZE 0x40 /* Register set size */
+
+#define MCFQSPI_CS0 29
+#define MCFQSPI_CS1 24
+#define MCFQSPI_CS2 21
+#define MCFQSPI_CS3 22
+
/*
* DMA unit base addresses.
*/
#if defined(CONFIG_M527x) || defined(CONFIG_M528x)
#define MCFQSPI_IOBASE (MCF_IPSBAR + 0x340)
-#elif defined(CONFIG_M5249)
-#define MCFQSPI_IOBASE (MCF_MBAR + 0x300)
#elif defined(CONFIG_M532x)
#define MCFQSPI_IOBASE 0xFC058000
#endif
#if defined(CONFIG_SPI_COLDFIRE_QSPI) || defined(CONFIG_SPI_COLDFIRE_QSPI_MODULE)
static struct resource m5249_qspi_resources[] = {
{
- .start = MCFQSPI_IOBASE,
- .end = MCFQSPI_IOBASE + MCFQSPI_IOSIZE - 1,
+ .start = MCFQSPI_BASE,
+ .end = MCFQSPI_BASE + MCFQSPI_SIZE - 1,
.flags = IORESOURCE_MEM,
},
{
},
};
-#define MCFQSPI_CS0 29
-#define MCFQSPI_CS1 24
-#define MCFQSPI_CS2 21
-#define MCFQSPI_CS3 22
-
static int m5249_cs_setup(struct mcfqspi_cs_control *cs_control)
{
int status;