static int tegra_crtc_setup_clk(struct drm_crtc *crtc,
struct drm_display_mode *mode)
{
- unsigned long pclk = mode->clock * 1000, rate;
+ unsigned long pclk = mode->clock * 1000;
struct tegra_dc *dc = to_tegra_dc(crtc);
struct tegra_output *output = NULL;
struct drm_encoder *encoder;
return -ENODEV;
/*
- * This assumes that the display controller will divide its parent
- * clock by 2 to generate the pixel clock.
+ * This assumes that the parent clock is pll_d_out0 or pll_d2_out
+ * respectively, each of which divides the base pll_d by 2.
*/
- err = tegra_output_setup_clock(output, dc->clk, pclk * 2);
+ err = tegra_output_setup_clock(output, dc->clk, pclk, &div);
if (err < 0) {
dev_err(dc->dev, "failed to setup clock: %ld\n", err);
return err;
}
- rate = clk_get_rate(dc->clk);
- div = (rate * 2 / pclk) - 2;
-
- DRM_DEBUG_KMS("rate: %lu, div: %u\n", rate, div);
+ DRM_DEBUG_KMS("rate: %lu, div: %u\n", clk_get_rate(dc->clk), div);
value = SHIFT_CLK_DIVIDER(div) | PIXEL_CLK_DIVIDER_PCD1;
tegra_dc_writel(dc, value, DC_DISP_DISP_CLOCK_CONTROL);
int (*enable)(struct tegra_output *output);
int (*disable)(struct tegra_output *output);
int (*setup_clock)(struct tegra_output *output, struct clk *clk,
- unsigned long pclk);
+ unsigned long pclk, unsigned int *div);
int (*check_mode)(struct tegra_output *output,
struct drm_display_mode *mode,
enum drm_mode_status *status);
}
static inline int tegra_output_setup_clock(struct tegra_output *output,
- struct clk *clk, unsigned long pclk)
+ struct clk *clk, unsigned long pclk,
+ unsigned int *div)
{
if (output && output->ops && output->ops->setup_clock)
- return output->ops->setup_clock(output, clk, pclk);
+ return output->ops->setup_clock(output, clk, pclk, div);
return output ? -ENOSYS : -EINVAL;
}
}
static int tegra_output_dsi_setup_clock(struct tegra_output *output,
- struct clk *clk, unsigned long pclk)
+ struct clk *clk, unsigned long pclk,
+ unsigned int *divp)
{
struct tegra_dc *dc = to_tegra_dc(output->encoder.crtc);
struct drm_display_mode *mode = &dc->base.mode;
unsigned int timeout, mul, div, vrefresh;
struct tegra_dsi *dsi = to_dsi(output);
unsigned long bclk, plld, value;
- struct clk *base;
int err;
err = tegra_dsi_get_muldiv(dsi->format, &mul, &div);
if (err < 0)
return err;
+ DRM_DEBUG_KMS("mul: %u, div: %u, lanes: %u\n", mul, div, dsi->lanes);
vrefresh = drm_mode_vrefresh(mode);
+ DRM_DEBUG_KMS("vrefresh: %u\n", vrefresh);
+ /* compute byte clock */
pclk = mode->htotal * mode->vtotal * vrefresh;
bclk = (pclk * mul) / (div * dsi->lanes);
- plld = DIV_ROUND_UP(bclk * 8, 1000000);
- pclk = (plld * 1000000) / 2;
+
+ /*
+ * Compute bit clock and round up to the next MHz.
+ */
+ plld = DIV_ROUND_UP(bclk * 8, 1000000) * 1000000;
+
+ /*
+ * We divide the frequency by two here, but we make up for that by
+ * setting the shift clock divider (further below) to half of the
+ * correct value.
+ */
+ plld /= 2;
err = clk_set_parent(clk, dsi->clk_parent);
if (err < 0) {
return err;
}
- base = clk_get_parent(dsi->clk_parent);
-
- /*
- * This assumes that the parent clock is pll_d_out0 or pll_d2_out
- * respectively, each of which divides the base pll_d by 2.
- */
- err = clk_set_rate(base, pclk * 2);
+ err = clk_set_rate(dsi->clk_parent, plld);
if (err < 0) {
dev_err(dsi->dev, "failed to set base clock rate to %lu Hz\n",
- pclk * 2);
+ plld);
return err;
}
+ /*
+ * Derive pixel clock from bit clock using the shift clock divider.
+ * Note that this is only half of what we would expect, but we need
+ * that to make up for the fact that we divided the bit clock by a
+ * factor of two above.
+ *
+ * It's not clear exactly why this is necessary, but the display is
+ * not working properly otherwise. Perhaps the PLLs cannot generate
+ * frequencies sufficiently high.
+ */
+ *divp = ((8 * mul) / (div * dsi->lanes)) - 2;
+
/*
* XXX: Move the below somewhere else so that we don't need to have
* access to the vrefresh in this function?
}
static int tegra_output_hdmi_setup_clock(struct tegra_output *output,
- struct clk *clk, unsigned long pclk)
+ struct clk *clk, unsigned long pclk,
+ unsigned int *div)
{
struct tegra_hdmi *hdmi = to_hdmi(output);
- struct clk *base;
int err;
err = clk_set_parent(clk, hdmi->clk_parent);
return err;
}
- base = clk_get_parent(hdmi->clk_parent);
-
- /*
- * This assumes that the parent clock is pll_d_out0 or pll_d2_out
- * respectively, each of which divides the base pll_d by 2.
- */
- err = clk_set_rate(base, pclk * 2);
+ err = clk_set_rate(hdmi->clk_parent, pclk);
if (err < 0)
- dev_err(output->dev,
- "failed to set base clock rate to %lu Hz\n",
- pclk * 2);
+ dev_err(output->dev, "failed to set clock rate to %lu Hz\n",
+ pclk);
+
+ *div = 0;
return 0;
}
}
static int tegra_output_rgb_setup_clock(struct tegra_output *output,
- struct clk *clk, unsigned long pclk)
+ struct clk *clk, unsigned long pclk,
+ unsigned int *div)
{
struct tegra_rgb *rgb = to_rgb(output);
+ int err;
+
+ err = clk_set_parent(clk, rgb->clk_parent);
+ if (err < 0) {
+ dev_err(output->dev, "failed to set parent: %d\n", err);
+ return err;
+ }
- return clk_set_parent(clk, rgb->clk_parent);
+ /*
+ * We may not want to change the frequency of the parent clock, since
+ * it may be a parent for other peripherals. This is due to the fact
+ * that on Tegra20 there's only a single clock dedicated to display
+ * (pll_d_out0), whereas later generations have a second one that can
+ * be used to independently drive a second output (pll_d2_out0).
+ *
+ * As a way to support multiple outputs on Tegra20 as well, pll_p is
+ * typically used as the parent clock for the display controllers.
+ * But this comes at a cost: pll_p is the parent of several other
+ * peripherals, so its frequency shouldn't change out of the blue.
+ *
+ * The best we can do at this point is to use the shift clock divider
+ * and hope that the desired frequency can be matched (or at least
+ * matched sufficiently close that the panel will still work).
+ */
+
+ *div = ((clk_get_rate(clk) * 2) / pclk) - 2;
+
+ return 0;
}
static int tegra_output_rgb_check_mode(struct tegra_output *output,
}
static int tegra_output_sor_setup_clock(struct tegra_output *output,
- struct clk *clk, unsigned long pclk)
+ struct clk *clk, unsigned long pclk,
+ unsigned int *div)
{
struct tegra_sor *sor = to_sor(output);
int err;
/* round to next MHz */
- pclk = DIV_ROUND_UP(pclk / 2, 1000000) * 1000000;
+ pclk = DIV_ROUND_UP(pclk, 1000000) * 1000000;
err = clk_set_parent(clk, sor->clk_parent);
if (err < 0) {
err = clk_set_rate(sor->clk_parent, pclk);
if (err < 0) {
- dev_err(sor->dev, "failed to set base clock rate to %lu Hz\n",
- pclk * 2);
+ dev_err(sor->dev, "failed to set clock rate to %lu Hz\n", pclk);
return err;
}
+ *div = 0;
+
return 0;
}
projects / karo-tx-linux.git / commitdiff